SAW FILTER PART NO.: ACTF2153-140-SMP53 The ACTF2153-140-SMP53 is a high performance IF band pass filter in a surface-mount ceramic SMP-53 case with center frequency 140.00 MHz. 1. Package Dimension (SMP-53) Pin Configuration 5 Output 6 Output-Ground 11 Input 12 Input -Ground Others Be grounded Unit: mm 2. Marking ACTF * 2153 - The logo “ACT” indicates our product mark - The character “F” indicates the type of SAW component. Including: F (filter), R (resonator) etc. - The “2153” indicates the model name of SAW component - The dot “·”indicates terminal 1 -* Date code 3. Matching Network (Input and output unbalanced) L1=120nH C1=36pF Iss 1 C1u L2=82nH L3=68nH Date 13-7-2011 Page 1 of 3 (Notes: Component values may change depending on board layout.) 4. Typical Response Iss 1 C1u Frequency Response Pass Band Response Group delay Variation Phase Linearity S11 Smith Chart S22 Smith Chart Date 13-7-2011 Page 2 of 3 5. Performance 5-1. Maximum Ratings Rating Value Unit Source Power PS 25 dBm DC Voltage VDC 0 V Storage Temperature Range Tstg -40 to +85 °C Operating Temperature Range TA -40 to +85 °C 5-2. Electronic Characteristics Parameter Center Frequency Insertion Loss* @CF 1dB Bandwidth 3dB Bandwidth 40dB Bandwidth Ultimate Attenuation @CF+-7.5MHz Input Return Loss Output Return Loss Passband Ripple CF+/-3.0MHz Group Delay Variation Absolute Delay Temperature Coefficient ESD/MSD Operational Temperature Unit Min. Typ. Max. MHz dB MHz MHz MHz 6.0 - 140.0 12.0 6.5 7.2 9.4 14.0 10.5 dB 42 48 - 10 6 - 0.5 1.0 - 70 1.23 -18 120 dB dB nsec usec PPM/°C 1A/1 °C -45 85 CAUTION: Electrostatic Sensitive Device. Observe precautions for handling! 1. 2. 3. 4. 5. 6. The frequency fC is defined as the midpoint between the 3dB frequencies. Unless noted otherwise, all measurements are made with the filter installed in the specified test fixture that is connected to a 50Ω test system with VSWR≤1.2:1. The test fixture L and C are adjusted for minimum insertion loss at the filter center frequency, fC. Note that insertion loss, bandwidth, and passband shape are dependent on the impedance matching component values and quality. Unless noted otherwise, specifications apply over the entire specified operating temperature range. The specifications of this device are based on the test circuit shown above and subject to change or obsolescence without notice. All equipment designs utilizing this product must be approved by the appropriate government agency prior to manufacture or sale. Our liability is only assumed for the Surface Acoustic Wave (SAW) component(s) per se, not for applications, processes and circuits implemented within components or assemblies. Iss 1 C1u Date 13-7-2011 Page 3 of 3