Available as: RF AMPLIFIER MODEL TM3115PM Typical Intermodulation Performance at 25 º C Features n n n n Second Order Harmonic Intercept Point ....... +40 dBm (Typ.) Second Order Two Tone Intercept Point ........ +35 dBm (Typ.) Third Order Two Tone Intercept Point ............ +30 dBm (Typ.) Low Phase Noise Bipolar Design High Output Power: 27 dBm Typical Operating Temp. -55 ºC to +85 ºC Environmental Screening Available Absolute (No Damage) Maximum Ratings Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature .................................-62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +17 Volts Continuous RF Input Power .................................. +15 dBm Short Term RF Input Power ..... 50 Milliwatts (1 Minute Max.) Maximum Peak Power ................... 0.1 Watt (3 µsec Max.) Specifications CHARACTERISTIC TYPICAL Ta= 25 ºC 10 - 1400 MHz Frequency Gain MIN/MAX Ta = -55 ºC to +85 ºC 10 - 1400 MHz 13.0 dB 11.5 dB Min. 27 dBm 24 dBm 22 dBm 25 dBm Min. 22 dBm Min. 20 dBm Min. Power @ 1 dB Comp. (10-1000 MHz) (1000-1200 MHz) (1200-1400 MHz) Reverse Isolation (dB) VSWR -17 dB 1.8:1 1.8:1 2.2:1 Max. 2.0:1 Max. Noise Figure (dB) 8.0 dB 10.0 dB Max. +15 volts 195 mA +15 volts 210 mA Max. Vdc mA Guaranteed Phase Noise Performance (dBc/Hz) Frequency 10 Hz 100 Hz 1 kHz 10 kHz 100 kHz 1 MHz - In Out Power TM3115PM, 4 Pin TO-8 (T4) TN3115PM, 4 Pin .450” sq. Surface Mount (SM3) BXF3115PM, SMA Connectorized Housing (H1) Typical -143 -153 -167 -170 -175 -175 Guarantee -135 -145 -155 -165 -170 -170 Note: Care should always be taken to effectively ground the case of each unit. (Measured in a 50 Ohm system @ +15 Volts DC nominal unless otherwise noted) Revision 9-3-2013 Typical Performance Data Gain (dB) 15 0 14 -10 13 -20 12 -30 11 Stop 1400 MHz Start 10 MHz +28 -40 -150 -160 Stop 1400 MHz Start 10 MHz -170 Noise Figure (dB) 10 8 +24 6 +22 4 Start 10 MHz Stop 1400 MHz -180 -190 10 Start 10 MHz Input VSWR 2.0 1.5 1.5 Stop 1400 MHz Start 10 MHz Legend +25 ºC 1.0 100 1k 10k 100k _______Guarantee __ __ __ Typical 2 2.0 1.0 Phase Noise (dBc/Hz) -130 -140 1 dB Comp. (dBm) +26 +20 Reverse Isolation (dB) Stop 1400 MHz Phase Noise Test Conditions: * Residual Carrier Frequency: 1280 MHz Power Output: +24.0 dBm Output VSWR Temperature: 25 ºC Agilent ES5500 System Start 10 MHz Stop 1400 MHz +85 ºC - - - - - - -55 ºC Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pa. 19154 · PH (215) 464-4000 · Fax (215) 464-4001 1M