Model Selection Guide Model Number D301RP D302RP D303RP D304RP D305RP D311RP D312RP D313RP D314RP D315RP D321RP D322RP D323RP D324RP D325RP Notes: Input Voltage (VDC) Current (mA) Nominal Range Full-Load No-Load 5 4.5 - 5.5 895 90 5 4.5 - 5.5 895 90 5 4.5 - 5.5 833 90 5 4.5 - 5.5 833 90 5 4.5 - 5.5 857 90 12 10.8 - 13.2 373 60 12 10.8 - 13.2 373 60 12 10.8 - 13.2 347 60 12 10.8 - 13.2 347 60 12 10.8 - 13.2 357 60 24 21.6 - 26.4 192 30 24 21.6 - 26.4 192 30 24 21.6 - 26.4 179 30 24 21.6 - 26.4 179 30 24 21.6 - 26.4 174 30 1. Output load regulation is specified for a load change of 20% to 100%. 2. When measuring output ripple, it is recommended that an external 0.33 μF ceramic capacitor be placed from the +Vout pin to the -Vout pin. 3. Operation at no-load will not damage these units. However, they may not meet all specifications. 4. These do not require external components to operate, but the use of a low ESR capacitor (approximately 10 uF, ESR <1.0Ω at 100 kHz) mounted close to the converter input pins is recommended. 5. It is recommended that a fuse be used on the input of a power supply for protection. See the table above for the correct rating. Capacitive Load Voltage (VDC) 5.0 9.0 12.0 15.0 24.0 5.0 9.0 12.0 15.0 24.0 5.0 9.0 12.0 15.0 24.0 Output Current (mA, Max) 600.0 333.0 250.0 200.0 125.0 600.0 333.0 250.0 200.0 125.0 600.0 333.0 250.0 200.0 125.0 Current (mA, Min) 60.0 33.0 25.0 20.0 12.5 60.0 33.0 25.0 20.0 12.5 60.0 33.0 25.0 20.0 12.5 Efficiency (%, Typ) 67 67 72 72 70 67 67 72 72 70 65 65 70 70 72 Fuse Rating Slow-Blow (mA) 1,500 1,500 1,500 1,500 1,500 700 700 700 700 700 350 350 350 350 350 Derating Curve Pin Connections μF Max 470 Pin Function 1 +Vin 2 NC 3 NC 9 NC 10 -Vout 11 +Vout 12 -Vin Mechanical Dimensions NC: No Connection Notes: All dimensions are typical in inches (mm) Tolerance x.xx = ±0.01 (±0.25) Pin 1 is marked by a “dot” or indentation on the side of the unit MicroPower Direct www.micropowerdirect.com 232 Tosca Drive Stoughton, MA 02072 ■ TEL: (781) 344-8226 ■ FAX: (781) 344-8481 ■ E-Mail: [email protected]