The ACTF2068-140-SMP53 is a high performance IF band pass filter in a surface-mount ceramic SMP-53 case with center frequency 140.00 MHz. 1. Package Dimension (SMP-53) Pin Configuration 5 Input or balanced Input 6 Input-Ground or balanced Input 11 Output or balanced Output 12 Output-Ground or balanced Output Others be grounded Unit: mm 3. Matching Network (Input and output unbalanced) 2. Marking Laser Marking 4. Typical Frequency Response Iss1 C1u, Date 13-7-2011 Page 1 of 2 5. Performance 5-1. Maximum Ratings Rating Value Unit Source Power (s. imp. 50Ω, duty cycle 1:100) PS 20 dBm Source Power (source impedance 50Ω) PS 10 dBm DC Voltage VDC 0 V Storage Temperature Range Tstg -40 to +85 °C Operating Temperature Range TA -40 to +85 °C 5-2. Electronic Characteristics Characteristic Minimum Typical Maximum Unit Center Frequency fC -- 140.00 -- MHz Insertion Loss (@140.00MHz) IL -- -- 13 dB BW3 18 -- -- MHz -- 0.5 0.9 dB -- 7 14 ° 46 50 56 60 --- dB dB 1.18 1.23 1.30 μs -- 80 140 ns -- -87 -- ppm/K 3dB Bandwidth Amplitude Ripple 132.00 …. 148.00 MHz Δα Phase Ripple (p-p) 132.00…. 148.00 MHz Δφ Relative Attenuation (relative to IL) 102.50 …. 112.50 MHz 180.18 …. 195.18 MHz αrel Group Delay at fC (@25 ) τC Group Delay Ripple (p-p) 132.00 …. 148.00 MHz Δτ Temperature Coefficient of Frequency TCf CAUTION: Electrostatic Sensitive Device. Observe precautions for handling! 1. 2. 3. 4. 5. 6. The frequency fC is defined as the midpoint between the 3dB frequencies. Unless noted otherwise, all measurements are made with the filter installed in the specified test fixture that is connected to a 50Ω test system with VSWR≤1.2:1. The test fixture L and C are adjusted for minimum insertion loss at the filter center frequency, fC. Note that insertion loss, bandwidth, and passband shape are dependent on the impedance matching component values and quality. Unless noted otherwise, specifications apply over the entire specified operating temperature range. The specifications of this device are based on the test circuit shown above and subject to change or obsolescence without notice. All equipment designs utilizing this product must be approved by the appropriate government agency prior to manufacture or sale. Our liability is only assumed for the Surface Acoustic Wave (SAW) component(s) per se, not for applications, processes and circuits implemented within components or assemblies. Iss1 C1u, Date 13-7-2011 Page 2 of 2