CUSTOMER DRAWING ADHESIVE OUTER SLEEVE PRODUCT DIMENSION I.D. (A) Cut Length (B) Adhesive Sleeve Adhesive Sleeve ± .05 (.002) ± .05 (.002) ± 1.5 (.05) ± .5 (.02) 1.11 (.044) 2.29 (.090) 19.75 (.78) 19.05 (.75) PART DESCRIPTION COLOR CODE D-150-C-11 Green D-150-C-12 Red 1.68 (.066) 2.74 (.108) 20.75 (.78) D-150-C-13 Blue 2.13 (.084) 3.43 (.135) D-150-C-14 Yellow 3.34 (.133) 4.80 (.189) AWG CONDUCTOR Wire O.D. (Note*) Min Max Min Max 26 24 0.80 (.031) 1.10 (.043) 19.05 (.75) 22 20 1.10 (.043) 1.50 (.059) 20.75 (.82) 19.05 (.75) 18 16 1.50 (.059) 2.30 (.090) 20.75 (.82) 19.05 (.75) 14 12 2.30 (.090) 2.80 (.110) MATERIALS 1. MELTABLE ADHESIVES: Environment resistant modified thermoplastic fluoroelastomer. Color coded. 2. INSULATION SLEEVE: Heat-shrinkable, transparent, radiation cross-linked modified fluoropolymer. Color coded. APPLICATION 1. These parts are designed to provide an environment resistant to repair damaged primary wire that have a radial crack up to 360 degrees, nicks/scrapes not longer than ¼” on the insulation rated for 135C minimum and no damage to wire conductor. For insulations procedures refer to RPIP 1101. 2. Install using Tyco Electronics approved convection or infrared heating tools in accordance with Tyco Electronics. When installed with approved convection or infrared heating tools, assemblies will meet the performance requirements of TE D-6201 spec. Infrared tools are not recommended for use with black cable jackets. 3 Temperature range: -65C to +150C. NOTE*: If the O.D. of wire is out of the range that is specified in Table, use the next size of C-Wrap up or down. W IR E O D TITLE: SIDE ENTRY REPAIR SLEEVE IMMERSION RESISTANT, 150 DEG C, RoHS COMPLIANT C-WRAP Unless otherwise specified dimensions are in millimeters.[Inches dimensions are shown in brackets] Raychem DIMENSIONING AND TOLERANCING PER GPS Devices (ISO STANDARDS) ANGLES: ± 0°30’ Tyco Electronics Corporation reserves TOLERANCES: the right to amend this drawing at any ROUGHNESS 0.00 ± 0.02 MM time. Users should evaluate the 0.0 ± 0.2 MM IN MICRON suitability of the product for their 0 ± 0.5 MM application. PREPARED BY: CAGE CODE: ECO NUMBER: DOCUMENT NO.: D-150-C-1X REV: DATE: A3 SCALE: YNGUYEN 06090 ECO-12-012452 © 2012 Tyco Electronics Corporation. All rights reserved. If this document is printed it becomes uncontrolled. Check for the latest revision. July 6, 2012 SIZE: NTS A SHEET: 1 of 1