Description Body Pin Insulation Snaps Crimp Ring Insulator Cover Heat Shrink Material Brass Brass Teflon BE CU Brass Teflon Brass Polyolefin Finish Gold Gold Teflon Gold Gold Gold Nickel Black REVISIONS REV SIDE VIEW DESCRIPTION DATE APPV 0.270 (6.85) 0.104 (2.65) 0.138 (3.50) COVER INSULATOR Ø0.093 (2.35) 0.354 (9.00) CRIMP RING BARREL 0.197 (5.00) Ø0.126 (3.20) Assembly Instructions 1. Strip coax as shown. Put heat shrink, then crimp ring onto cable. 2. Slide the coax into the body until the center conductor is centered in the fork. 3. Push the shield over the barrel. 4. Solder the center conductor into center of the fork. 5. Slide the crimp ring over the shield and crimp with a 0.100” crimp die. 6. Trim off any excess shield wire sticking out from the ring. 7. Slip the heat shrink tube over the crimp ring until it is against the body and then heat shrink. 8. Slip insulator into body. 9. Push cover into the opening. RECOMMENDED CABLE STRIPPING DIMENSIONS 0.028 (0.70) 0.059 (1.50) 0.217 (5.50) RG-178 Cable Ø0.079 (2.00) Ø0.118 (3.00) 0.787 (20.00) NOTES: (UNLESS OTHERWISE SPECIFIED) 1. ALL DIMENSIONS ARE IN INCHES [mm]. 2. DIMENSIONS APPLY AFTER FINISHING. 3. MANUFACTURE TO BE COMPLIANT WITH EU RoHS DIRECTIVE. 4. SAFETY BREAK ALL SHARP CORNERS AND EDGES .02 MAXIMUM. WARNING: THIS DRAWING CONTAINS PROPRIETARY INFORMATION THAT IS THE SOLE PROPERTY OF CONNECTOR CITY, AND SHALL BE TREATED AS SUCH. NO DISCLOSURE OR REPRODUCTION OF THIS DOCUMENT IS PERMITTED, IN WHOLE OR IN PART, WITHOUT THE EXPRESS WRITTEN PERMISSION OF CONNECTOR CITY OR ITS DESIGNATED AGENTS. MATERIAL: FINISH: BRAIDED SHIELD HEAT SHRINK 0.276 (7.00) PROJECTION: TOLERANCES: .020 [0.50]-.200 [5.00]= .008 [0.20] .200 [5.00]-1.200 [30.00]= .016 [0.40] 1.20 [30.0]-4.75 [120.0]= .024 [0.60] 4.75 [120.0]-12.40 [315.0]= .040 [1.0] ANGLES: 1 DRAWN: ENGR: CJ DT: 7/27/09 DT: 159 ORT LANE MERLIN, OR 97532 TITLE: MMCX MALE RIGHT ANGLE CABLE END CRIMP FOR RG178 CABLE SIZE DWG. NO. CONMMCX012-R178 A SCALE: 2:1 DO NOT SCALE DRAWING REV B SHEET 1 OF 1 LDCFDCC_A