Strain Reliefs AS85049/38 Strain Relief Glenair Connector Designator H MIL-DTL-38999 Series III & IV, EN3645 M85049/38 S 11 W Basic Part No. Material and Finish Designator A = Aluminum, Black Anodize N = Aluminum, Electroless Nickel S = 300 Series Steel, Passivated W = Aluminum, 500 Hour Cadmium Olive Drab Over Electroless Nickel S = Self-Locking Use Dash for Non-Self-Locking Shell Size A Thread Cable Entry F Self-Locking Only E Self-Locking Only H Note: Screw orientation shown is for non-self-locking configuration. Screws on self-locking configurations are on the same side/face of the clamp. TABLE I Shell Shell Size Size Ref. 9 A 11 B 13 C 15 D 17 E 19 F G 21 23 H 25 J A Thread Class 2B M12 X 1 - 6H M15 X 1 - 6H M18 X 1 - 6H M22 X 1 - 6H M25 X 1 - 6H M28 X 1 - 6H M31 X 1 - 6H M34 X 1 - 6H M37 X 1 - 6H E Dia Max Self-Locking Only .858 (21.8) .984 (25.0) 1.157 (29.4) 1.279 (32.5) 1.406 (35.7) 1.516 (38.5) 1.642 (41.7) 1.768 (44.9) 1.889 (48.0) F Max Self-Locking Only .91 (23.1) .91 (23.1) 1.01 (25.7) 1.06 (26.9) 1.16 (29.5) 1.41 (35.8) 1.51 (38.4) 1.66 (42.2) 1.76 (44.7) H Max .85 (21.6) .90 (22.9) 1.10 (27.9) 1.15 (29.2) 1.30 (33.0) 1.50 (38.1) 1.60 (40.6) 1.70 (43.2) 1.80 (45.7) Cable Entry Max Min .098 (2.5) .234 (5.9) .153 (3.9) .234 (5.9) .190 (4.8) .328 (8.3) .260 (6.6) .457 (11.6) .283 (7.2) .614 (15.6) .325 (8.3) .634 (16.1) .343 (8.7) .698 (17.7) .381 (9.7) .823 (20.9) .418 (10.6) .853 (21.7) 1. For complete dimensions see applicable Military Specification. 2. Metric dimensions (mm) are indicated in parentheses. 3. Cable Entry is defined as the accomodation entry for the wire bundle or cable. Dimensions are not intended for inspection criteria. © 2005 Glenair, Inc. CAGE Code 06324 Printed in U.S.A. GLENAIR, INC. • 1211 AIR WAY • GLENDALE, CA 91201-2497 • 818-247-6000 • FAX 818-500-9912 www.glenair.com E-Mail: [email protected] 62-11