ETC2 HY2001 Data sheet hy2001 30 watt Datasheet

DATA SHEET
HY2001 30 WATTS
The ILP HY2001 Power Amplifier is a fully
encapsulated high quality power amplifier
with Integral Power Supply and heatsink.
By selecting the appropiate mains transformer and the programming link on the
PCB the amplifier can be used with 4 or 8Ω loads with the automatic adjustment
of input sensitivity.
Mounting can be achieved by the use of T-slots in the heatsink and the nuts and
bolts provided.
TYPICAL SPECIFICATIONS
Parameter
Output Power
Frequency Response (-3dB)
Total Harmonic Distortion @ 1kHz
Signal to Noise Ratio (DIN AUDIO)
Slew Rate typical
Rise Time
Input Sensitivity
Input Impedance
Damping Factor(8Ω @ 100Hz)
Load Impedance (programmable)
Maximum D.C. rails (8Ω load)
Size Width x Height x Extrusion Cut
Weight
Value
40W rms. Max
15Hz - 50kHz
0.005%
100dB
10V/µS
5µS
500mV rms.
100KΩ
>400
4 or 8Ω
±30V
76x100x30mm
200g
POWER SUPPLY REQUIREMENTS
•
FEATURES
•
Programmable 4 or 8Ω
operation
•
Integral Power Supply
•
Anti-thump Circuitry
•
Integral heatsink
•
Thermal Protection
•
PTH Circuit Board
•
Encapsulated
ILP have developed a range of Hi-Fi quality Low noise Audio Power Toroidal
Transformers for the HY2001 they are Low Profile with Resin filled centres for
maximum noise absorption and ease of mounting. Finished in black to match the
amplifiers these transformers are the ideal choice to power the HY2001.
Mode
4Ω
8Ω
Transformer
AT0304
AT0308
RMS Supply Voltage
16 - 0 - 16v
20 - 0 - 20v
Size
90x34mm
90x34mm
SPONG LANE ELMSTED ASHFORD KENT TN25 5JU
PHONE +44 (0)1233 750481 FAX +44 (0)1233 750578
Weight
0.9Kg
0.9Kg
ELECTRICAL / MECHANICAL
DETAILS AND DIMENSIONS
INSTALLATION NOTES
1.
2.
3.
4.
For normal usage and conditions the amplifier needs no supplementary heatsink.
It must be mounted to allow a vertical flow of air through the fins.
No input capacitor is required. An internal 100V working capacitor is fitted.
For loudspeaker protection it is recommended that a quickblow fuse is mounted
between the output and the speaker. The fuse rating specified has been calculated
to ensure fast rupture in the event of DC being presented to the speaker. It is
advised not to use a higher rated fuse.
5. The amplifier module is supplied in 8Ω mode. To set 4Ω mode simply break the link
using a spot face cutter or a 3-5mm drill.
6. For 4Ω mode use a 2.0A quickblow fuse and for 8Ω a 1.5A quickblow fuse.
Similar pages