LEG-150W Series– Fixed Output and Dimmable Switch Mode LED Drivers Constant Current, Non-Isolated Black Magic Thermal Advantage™ Metallic Housing Electrical Specifications Input Voltage Range: 120-277 VAC Nom. (108-305 V Min/Max) Input Over-Voltage: Can endure 320Vac for 48 Hrs, 350Vac for 2 Hrs Frequency: 50/60 Hz Nom. (47-63 Hz Min/Max) Power Factor: >0.90 @ full load, 100V through 277V THD: < _ 20% @ for all loads >80% Inrush Current: <40.0 Amps maximum @ 230 VAC, cold start 25ºC Input Current: 1.4A@ 120Vac, 0.68A @ 230Vac Maximum Power: 150W Current Accuracy: ± 1% Over input line variation Load Regulation: ± 2% Leakage Current: 400 uA Typical Hold Up Time: Half Cycle Protection: utput Protection: Over-Voltage, Over-Current, and O Short Circuit Protection, reset by power cycling Environmental Specifications Minimum Starting Temp: -30ºC Maximum Case Temp. 80°C Storage Temperature: -40ºC to +85ºC Humidity: 5% to 95% Cooling: Convection Vibration Frequency: 5 to 55 Hz/2g, 30 minutes Sound Rating: Class A MTBF: 380,000 Hours at full load and 40ºC ambient conditions per MIL-217F Notice 2 EMC: FCC 47CFR Part 15 Class A compliant Impact Resistance: 1g/s Weight: 45 oz (1270 grams) Ordering Options: -D:0-10V & Resistance dimmable version comes with an extra two wires +Purple/-Gray on the output side. 0-10V Dimming is compatible with most quality 0-10V dimmers. See pg. 3 for more information. • Total Power: 75 Watts • Input Voltage: 100-277 Vac Nom. • UL Dry & Damp Location Rated • IP66 • High Power Factor • UL8750, EN61347, CSA 22.2 Constant Current - Non Dimming Model Number Output Voltage Range (Vdc) Output Current (mA ±3%) Max Output Power (W) Max Efficiency LEG150W-425-C0350 120-425 350 148.7 92% LEG150W-280-C0530 94-280 530 148.4 91% LEG150W-210-C0700 70- 210 700 147.0 90% Output Current (mA ±3%) Max Output Power (W) Max Efficiency Constant Current - 0-10VDC Dimming Model Number Output Voltage Range (Vdc) LEG150W-425-C0350-D 120-425 350 148.7 92% LEG150W-280-C0530-D 94-280 530 148.4 91% LEG150W-210-C0700-D 70-210 700 147.0 90% Sign Components Manual E332160 Note: LED drivers are designed and intended to operate LED loads only. Non-LED loading may be outside the specified design limits of our LED drivers, and therefore cannot be covered by any warranty. If you desire to use our LED drivers to operate non-LED loads please contact us to discuss compatibility. Specifications subject to change without notice. Rev 8-31-15 Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LEG150W Series SSL Solutions Faster Than The Speed Of Light® Pg 2 of 3 Dimensions - Inches (mm) OUTPUT Red (+) Blue (-) INPUT White (N) Black (L) Tc = 80°C max CASE MUST BE GROUNDED IN END USE APPLICATION Dimming Purple (+) Gray (-) WIRE SPECS: AC Input / DC Output / Dimming Control: • Solid Copper • 8 IN [203mm] • UL1316/1452 #18AWG Lifetime (kHrs) Lifetime/Case Temperature 300 275 250 225 200 175 150 125 100 75 50 25 0 (Full Load @ 120Vac) 40 45 50 55 60 65 70 75 Case Hotspot Temperature (°C) 80 Note: Life calculations are based on reliability with confidence using a 90% confidence level and <5% failure rate. At a confidence level of 90% it is expected that <5% of the parts will fail at the rated life provided. (Failure is defined as a driver drifting outside specification, rather than fail to operate) UL Conditions of Acceptability See website for additional information Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com LEG150W Series SSL Solutions Faster Than The Speed Of Light® Pg 3 of 3 “-D” Option: - 0-10VDC and Resistance Dimming Parameters Minimum Typical Maximum 0 mA -2.0 V — — 2 mA +15 V Source Current out of 0-10V Purple Wire Absolute Voltage Range on 0-10V (+) Purple Wire Typical Dimming Circuit Dim (+) Purple LEG150W-XX-CXXXX-D IP710 Wall Dimmer Dim (-) Gray (Dimmer must be current-sink type control) Output Current / 0-10VDC Dimming Input Output Current % 100 90 80 70 60 50 40 30 20 10 0 0V 1V 2V 3V 4V 5V 6V Dimming Input (Vdc) 7V 8V 9V 10V Notes: 1. 0-10V dimmable version comes with an extra two wires +Purple/-Gray on the output side. 2. When connected to a dimming device, 0-10V dimmable version will have a ±10% output current tolerance. This is due to variation between different 0-10V dimmers. 3. Compatible with most 0-10V Wall Slide dimmers and direct 0-10V analog signal. Recommended dimmer is Leviton IP710 or equivalent 4. 0-10V dimmable version is not intended to dim below about 5% @ 0V or 10% @ 1.0V 5. 0-10V dimmable version output will be 100% with Purple/Gray open and minimum with Purple/Gray Shorted. Thomas Research Products • 1225 Bowes Rd • Elgin, IL 60123 • T 847-515-3057 • F 847-515-3047 • www.trpssl.com