Movon Bluetooth Module Application Note Module Feature -Bluetooth® 2.0 Spec Com pliant -Bluetooth® Class2 and Class3 Support -Full Bluetooth data rate over UART and USB -Internal Stereo Audio CODEC Features -Size(12.5 X 14.2 X 2.2mm) -Class2 and 3 Support al -Surface Mountable -Single 2.8 ~3.3V Power Supply (MD-10MMXX33) ti Specification -Operating Conditions n Support Voltage : 1.70V~1.85V -Radio Characteristics Receiver Sensitivity : -82dBm de Temperature Range : -20~+70°C ( -40~+90C available ) Transmitter Power : +2.0dBm(Typical) -Audio Interface Characteristics fi Input full scale at maximum gain : 4mV rms Input full scale at minimum gain : 400mV rm C on Max Output Voltage : 2.0 Vpk-pk Power Consumption -Stand by Mode : 1mA -Pairing Mode : 30mA -(Mono)Talking Mode : 30mA -(Stereo)Playing Mode : 40mA Copyright © 2005, Movon Corporation All specification are preliminary and Movon reserves the right to change these without notice. http://www.movon.co.kr Movon Bluetooth Module Application Note MD-10MM Rev 1.0 Pin Description Pin No. Pin Name 1 GN D 2 ANT 3 GN D Description Pad Type Common Ground VSS Connect to Antenna(for RF Signal) Analogue Common Ground VSS AUD_OUT_RP Speaker output positive (Right channel) Analogue 5 AUD_OUT_RN Speaker output negative (Right channel) Analogue 6 AUD_OUT_LP Speaker output positive (Left channel) Analogue 7 AUD_OUT_LN Speaker output negative (Left channel) Analogue 8 AUD_IN_LN Microphone & Audio Signal input negative(Left channel) Analogue 9 AUD_IN_LP Microphone & Audio Signal input positive(Left channel) Analogue 10 AUD_IN_RP Microphone & Audio Signal input positive (Right Analogue al 4 channel) AUD_IN_RN Microphone & Audio Signal input negative(Right channel) ti 11 Analogue AIO_0 Programmable input/output line 13 GN D Common Ground 14 AIO_1 Programmable input/output line 15 AIO_3 Programmable input/output line Bi-directional 16 PIO_6 Programmable input/output line Bi-directional 17 PIO_7 Programmable input/output line Bi-directional 18 PIO_5 Programmable input/output line Bi-directional 19 PIO_4 Programmable input/output line Bi-directional 20 USB _DN USB data minus Bi-directional 21 USB_DP USB data plus Bi-directional 22 VDD_IN Module power supply VDD 23 GN D Common Ground VSS 24 UART_RTS UART request to send active low CMOS output Tri-state 25 UART_CTS UART clear to send active low CMOS input 26 UART_TX UART data output CMOS output Tri-state 27 UART_RX UART data input CMOS input 28 PCM_IN Pulse Code Modulation Synchronous data input CMOS input 29 PCM_CLK Pulse Code Modulation Synchronous data clock Bi-directional 30 PCM_SYNC Pulse Code Modulation Synchronous data sync Bi-directional 31 PCM_OUT Pulse Code Modulation Synchronous data output CMOS output Tri-state 32 RESET_IN Module reset input. Reset if high>5ms to cause a reset CMOS input 33 SPI_MOSI Serial Peripheral Interface data input CMOS input C on fi de n 12 Bi-directional VSS Bi-directional Copyright © 2005, Movon Corporation All specification are preliminary and Movon reserves the right to change these without notice. http://www.movon.co.kr Movon Bluetooth Module Application Note SPI_CLK Serial Peripheral Interface data clock CMOS input 35 SPI_MISO Serial Peripheral Interface data output CMOS output Tri-state 36 SPI_CSB Chip select for Synchronous Serial Interface active low CMOS input 37 PIO_0 Programmable input/output line Bi-directional 38 PIO_1 Programmable input/output line Bi-directional 39 PIO_11 Programmable input/output line Bi-directional 40 PIO_9 Programmable input/output line Bi-directional 41 PIO_10 Programmable input/output line Bi-directional 42 PIO_8 Programmable input/output line Bi-directional 43 PIO_2 Programmable input/output line Bi-directional 44 PIO_3 Programmable input/output line Bi-directional 45 AUX_DAC Voltage DAC output Analogue 46 GN D Common Ground al 34 C on fi de n ti VSS Copyright © 2005, Movon Corporation All specification are preliminary and Movon reserves the right to change these without notice. http://www.movon.co.kr A B C D L1 1 2 TBD TBD C8 TBD C6 C7 TBD C5 1 Single Ended Input MIC X2 MIC 1 2 2 1 SP2 LEFT X1 2 1 SP1 RIGHT C2 TBD Antenna Matching Circuit TBD C1 TBD T1 ANT 2 2 1 3 2 45 12 14 15 37 38 43 44 19 18 16 17 42 40 41 39 9 8 10 11 6 7 4 5 RF_IN/OUT GND GND U3 VDD_IN GND MD-10MM AUX_DAC AIO_0 AIO_1 AIO_3 PIO_0 PIO_1 PIO_2 PIO_3 PIO_4 PIO_5 PIO_6 PIO_7 PIO_8 PIO_9 PIO_10 PIO_11 AUD_IN_LP AUD_IN_LN AUD_IN_RP AUD_IN_RN AUD_OUT_LP AUD_OUT_LN AUD_OUT_RP AUD_OUT_RN 36 35 34 33 31 30 29 28 22 23 GND GND RESET_IN USB_DN USB_DP UART_RX UART_TX UART_CTS UART_RTS 46 13 32 20 21 27 26 25 24 Copyright © 2005, Movon Corporation are preliminary and Movon reserves the right to change these without not http://www.movon.co.kr File A4 Size Title TP1 TP2 TP3 TP4 .docno. No. 4 C4 10uF 4 1 of 1 Connect to Host CPU(RS232 Data Transmit) Module Debug & Program Down Load Port BT_ENABLE VDD_BAT note1 note2 note3 Rev. note4 .rev. note5 Date 2005/05/19Time 15:36 VDD_1V8 CSB MISO CLK MOSI SWSPST SW1 RESET_IN EN 3 GND 2 XC6209182MR 4 BYP al title 3 U1 5 OUT VIN 1 UART_RX UART_TX UART_CTS UART_RTS 1 1 1 1 C3 2.2uF VDD_1V8 3 ti n SPI_CSB SPI_MISO SPI_CLK SPI_MOSI PCM_OUT PCM_SYNC PCM_CLK PCM_IN de fi on C Programable I/O Port(User Define) 1 A B C D Movon Bluetooth Module Application Note Example Schematic Circuit Movon Bluetooth Module Application Note Size & Dimensions -Unit : mm(+/-0.1) 2.2 2.2 0.8 0.8 37 46 36 n ti al 14.2 MOVON 1 Bottom View MD-10MM 24 23 14 de 12.5 Module Size & Pin Number fi 12.5 1.75 1.75 ............... .... ... . . . ... 1.1 .. . . .................. .. 1.0 1.1 ................. ... 1.75 1.0 0.6 . . .. C . ... .................. .. .. . 14.2 .. . . 1.0 ... 0.5 14.2 1.0 0.6 1.1 1.1 on 1.0 1.75 12.5 PCB Layout(Top View) Copyright © 2005, Movon Corporation All specification are preliminary and Movon reserves the right to change these without notice. http://www.movon.co.kr 13