ELD-700-524 rev 2.0 09.12.2015 Description ELD-700-524 is a AlGaAs based Light Emitting Diode with a typical peak wavelength of 700 nm and an optical output power of 10 mW. It is mounted on a lead frame and encapsulated in a standard clear 5 mm epoxy package. Maximum Ratings Parameter Power Dissipation Forward Current Peak Forward Current Operating Temperature Storage Temperature Junction Temperature Lead Soldering Temperature (TCASE=25°C) Symbol TCASE TSTG TJ TSLD Peak Wavelength Spectral Half Width (FWHM) Radiated Power Radiated Intensity Forward Voltage Reverse Voltage Viewing Angle Rise Time Fall Time www.roithner-laser.com 50 100 + 80 + 100 - 20 - 40 + 260 Symbol Conditions λP ∆λ0,5 ΦE IE VF VR φ tR tF Unit Max. PD IF IFP Optical and Electrical Characteristics Parameter Values Min. IF=50mA IF=50mA IF=50mA IF=50mA IF=50mA IR=10µA IF=50mA IF=50mA IF=50mA mW mA mA °C °C °C °C (TCASE=25°C) Min. 690 8 40 Values Typ. 700 30 10 70 2 5 20 40 40 Max. 710 2.4 Unit nm nm mW mW/sr V V deg. ns ns 1 Outline Dimensions ELD-700-524 5 mm epoxy All Dimensions in mm Precautions Cautions: DO NOT look directly into the emitted light or look through the optical system. To prevent in adequate exposure of the radiation, wear protective glasses. Operation: • Check your connection circuits before turning on the LED • Mind the LED polarity: LED anode is marked by long pin • Do only operate LEDs with a current source Soldering: • • • • • • • • • Do avoid overheating of the LED Do avoid electrostatic discharge (ESD) Do avoid mechanical stress, shock, and vibration Do only use non-corrosive flux Do only cut the leads at room temperature with an ESD protected tool Do not solder closer than 3 mm from base of the header Do form leads prior to soldering Do not impose mechanical stress on the header when forming the leads Do not apply current to the LED until it has cooled down to room temperature after soldering Static Electricity: LEDs are sensitive to electrostatic discharge (ESD). Precautions against ESD must be taken when handling or operating these LEDs. Surge voltage or electrostatic discharge can result in complete failure of the device. © All Rights Reserved The above specifications are for reference purpose only and subjected to change without prior notice www.roithner-laser.com 2