defining a degree of excellence 1 TAP LEADING EDGE CONTROL STANDARD DELAY MODULES Cat 18-R2 .300 5 Out Vcc 8 bel (DC) (P/N) .375 .350 .285 Max .300 * .325 In 1 bel (DC) (P/N) .285 Max Gnd 4 .50 Max .50 Max .015 .004 .22 Max 4o .23 Max .012 .008 .018 Coplanarity + .002 .012 .008 .030 Time Delay Thru-Hole S423-0005-06 A463-0005-06 5 ns S423-0007-06 A463-0007-06 S423-0010-06 A463-0010-06 S423-0015-06 A463-0015-06 7 ns 10 ns 15 ns S423-0020-06 S423-0025-06 S423-0030-06 S423-0035-06 A463-0020-06 A463-0025-06 A463-0030-06 A463-0035-06 20 25 30 35 S423-0040-06 A463-0040-06 S423-0045-06 A463-0045-06 S423-0050-06 A463-0050-06 S423-0075-06 A463-0075-06 S423-0100-06 A463-0100-06 ns ns ns ns 40 ns 45 ns 50 ns 75 ns 100 ns Rise Tolerance Time + 1.0 ns 3 ns + 1.0 ns + 1.5 ns + 1.5 ns + 1.5 ns + 1.5 ns + 2.0 ns + 2.0 ns + 2.0 ns 3 ns 3 ns 3 ns 3 3 3 3 3 ns ns ns ns ns + 2.0 ns + 2.5 ns + 3.5 ns + 5.0 ns 3 3 3 3 ns ns ns ns Tolerances Input to Output + 2 ns or 5% ,Unless otherwise specified Delays measured @ 1.5 V levels on Leading Edge only with no loads on Output Rise and Fall Times measured from 0.75 V to 2.4 V levels Drive Capabilities Nh Logic 1 Fanout Nl Logic 0 Fanout - Temp. 100o C 0 2 4 6 Ti m e i n M i n u t e s Pulse Voltage Rise Time Pulse Width Pulse Period Supply Current Supply Voltage 3.2 Volts 3.0 ns (10%-90%) 1.2 x Total Delay 4 x Pulse Width 35 ma Typical 5.0 Volts Electrical Characteristics Min. 4.75 2.0 Max. 5.25 Units V V V ma ma V V V ua ma ma ma ma C % % Vcc Vih Vil Ioh Iol Voh Vol Vik Iih Iil Ios Icch Iccl Ta PW d Supply Voltage Logic 1 Input Voltage Logic 0 Input Voltage Logic 1 Output Current Logic 0 Output Current Logic 1 Output Voltage Logic 0 Output voltage Input Clamp Voltage Logic 1 Input Current Logic 0 Input Current Short Circuit Output Current Logic 1 Supply Current Logic 0 Supply Current Operating Free Air Temperature Min. Input Pulse Width of Total Delay Maximum Duty Cycle Tc Temp. Coeff. of Total Delay (TD) 100 + (25000/TD) PPM/OC 0.8 -1 20 2.7 -60 0o 40 0.5 -1.2 20 -0.6 -150 25 40 70o 50 Transfer molded for better reliability Compatible with TTL & DTL circuits Terminals: Electro-Tin plate phosphor bronze Performance warranty is limited to specified parameters listed SMD - Tape & Reel available: 24mm Wide x 12mm Pitch, 750 pieces per 13" reel Infra Red 200 C .015 Min .045 .018 Notes 225o C Max Temp. > 185o C for 90 Seconds Max o Ein Trin PW PP Iccl Vcc 10 TTL Loads Max. 10 TTL Loads Max. Recommended Temperature Profile 300o C .12 Min Test Conditions @ 25oC Part Numbers SMD 100o 90o .20 Max 8 Other Delays and Tolerances Available Consult Sales Specifications subject to change without notice. Corporate Office Bel Fuse Inc. 198 Van Vorst Street, Jersey City, NJ 07302-4496 Tel: 201-432-0463 Fax: 201-432-9542 E-Mail: [email protected] Internet: http://www.belfuse.com 10 Far East Office Bel Fuse Ltd. 8F/8 Luk Hop Street San Po Kong Kowloon, Hong Kong Tel: 852-2328-5515 Fax: 852-2352-3706 European Office Bel Fuse Europe Ltd. Preston Technology Management Centre Marsh Lane, Preston PR1 8UD Lancashire, U.K. Tel: 44-1772-556601 Fax: 44-1772-888366