AD ADV7520 Low power hdmi/dvi transmitter with consumer electronic control (cec) Datasheet

Low Power HDMI/DVI Transmitter with
Consumer Electronic Control (CEC)
ADV7520
General
Low power HDMI/DVI transmitter ideal for portable
applications
CEC controller and buffer reduce system overhead
Incorporates HDMI (v.1.3 with x.v.Color) technology
Compatible with DVI v.1.0 and HDCP 1.3
Single 1.8 V power supply
Video/audio inputs accept logic levels from 1.8 V to 3.3 V
Digital video
80 MHz operation supports all HDTV resolutions from
480i to 1080i
Programmable 2-way color space converter
Supports RGB, YCbCr, and DDR
Supports ITU656-based embedded syncs
Automatic input video format timing detection (CEA-861D)
Digital audio
Supports standard S/PDIF for stereo LPCM or compressed
audio up to 192 kHz
8-channel, uncompressed LPCM I2S audio up to 192 kHz
Special features for easy system design
Embedded HDCP keys
On-chip MPU with I2C master to perform HDCP operations
and EDID reading operations
5 V tolerant I2C and HPD I/Os, no extra device needed
No audio master clock needed for supporting S/PDIF and I2S
On-chip MPU reports HDMI events through interrupts and
registers
APPLICATIONS
Digital video cameras
Digital still cameras
Personal media players
DVD players and recorders
Digital set-top boxes
A/V receivers
HDMI repeaters/splitters
FUNCTIONAL BLOCK DIAGRAM
INT
SCL SDA
I2C
SLAVE
HDCP
CORE
HDCP AND EDID
MICROCONTROLLER
REGISTER
CONFIGURATION
LOGIC
HDCP
KEYS
I2C
MASTER
CEC CONTROLLER
BUFFER
CLK
VSYNC
HSYNC
DE
VIDEO
DATA
CAPTURE
MCLK
SCLK
DDCSDA
CEC_IO
CEC_CLK
Tx0+/–
COLOR
SPACE
CONVERSION
S/PDIF
LRCLK
DDCSCL
SYNC
ADJUSTMENT
AND
GENERATION
D[23:0]
I2S[3:0]
HPD
AUDIO
DATA
CAPTURE
Tx1+/–
TMDS
OUTPUTS
Tx2+/–
ADV7520
TxC+/–
07349-001
FEATURES
Figure 1.
GENERAL DESCRIPTION
The ADV7520 is an 80 MHz, High-Definition Multimedia
Interface (HDMI™) transmitter with consumer electronic
control (CEC). It supports HDTV formats up to 720p and 1080i
and computer graphic resolutions up to XGA (1024 × 768 @
75 Hz). With the inclusion of HDCP, the ADV7520 allows the
secure transmission of protected content, as specified by the
HDCP 1.3 protocol.
pulse-code modulation (LPCM) audio or compressed audio,
including Dolby® Digital and DTS®.
The ADV7520 supports x.v.Color™ (Gamut Metadata) for a
wider color gamut.
The ADV7520 helps reduce system design complexity and cost
by incorporating features such as an internal microprocessor for
high-bandwidth digital content protection (HDCP) operations, an
I2C® master for extended display identification data (EDID)
reading, a single 1.8 V power supply, and 5 V tolerance on the
I2C and hot plug detect pins. For additional information and
resources, see the Applications Information section.
The ADV7520 supports both S/PDIF and 8-channel I2S audio. Its
high fidelity, 8-channel I2S can transmit either stereo or 7.1
surround audio at 192 kHz. The S/PDIF can carry stereo linear
Fabricated in an advanced CMOS process, the ADV7520
is available in a space saving, 64-lead LFCSP. The package is RoHS
compliant and is specified for −25°C to +85°C operation.
Rev. 0
Information furnished by Analog Devices is believed to be accurate and reliable. However, no
responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other
rights of third parties that may result from its use. Specifications subject to change without notice. No
license is granted by implication or otherwise under any patent or patent rights of Analog Devices.
Trademarks and registered trademarks are the property of their respective owners.
One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
Tel: 781.329.4700
www.analog.com
Fax: 781.461.3113
©2008 Analog Devices, Inc. All rights reserved.
ADV7520
TABLE OF CONTENTS
Features .............................................................................................. 1
ESD Caution...................................................................................4
Applications ....................................................................................... 1
Terminology .......................................................................................5
Functional Block Diagram .............................................................. 1
Applications Information .................................................................6
General Description ......................................................................... 1
Design Resources ..........................................................................6
Revision History ............................................................................... 2
Document Conventions ...............................................................6
Specifications..................................................................................... 3
Outline Dimensions ..........................................................................7
Absolute Maximum Ratings............................................................ 4
Ordering Guide .............................................................................7
Explanation of Test Levels ........................................................... 4
REVISION HISTORY
5/08—Revision 0: Initial Version
Rev. 0 | Page 2 of 8
ADV7520
SPECIFICATIONS
Table 1.
Parameter
DIGITAL INPUTS
Input Voltage, High (VIH)
Input Voltage, Low (VIL)
Input Capacitance
THERMAL CHARACTERISTICS
Thermal Resistance
Junction-to-Case (θJC)
Junction-to-Ambient (θJA)
Ambient Temperature
DC SPECIFICATIONS
Input Leakage Current (IIL)
AC SPECIFICATIONS
CLK Frequency
TMDS Output CLK Duty Cycle
Input Data Setup Time
Input Data Hold Time
TMDS Differential Swing
VSYNC and HSYNC Delay from DE Falling Edge
VSYNC and HSYNC Delay to DE Rising Edge
Differential Output Swing
Low-to-High Transition Time
High-to-Low Transition Time
AUDIO AC TIMING
Sample Rate
I2S Setup Time
I2S Hold Time
1
2
Conditions
I2S and S/PDIF
See the Explanation of Test Levels section.
UI = unit interval.
Rev. 0 | Page 3 of 8
Temp
Test Level1
Min
Full
Full
25°C
VI
VI
VIII
1.4
−0.3
Full
V
V
V
−25
Full
VI
Full
Full
Full
Full
Typ
Max
Unit
3.5
+0.7
1.5
V
V
pF
+85
°C/W
°C/W
°C
−1
+1
μA
IV
IV
IV
IV
VI
IV
IV
13.5
48
1
0.7
900
80
52
MHz
%
ns
ns
mV
UI2
UI2
25°C
25°C
VII
VII
75
75
Full
25°C
25°C
IV
IV
IV
32
2
2
15.2
59
+25
1000
1
1
1100
175
175
ps
ps
192
kHz
ns
ns
ADV7520
ABSOLUTE MAXIMUM RATINGS
EXPLANATION OF TEST LEVELS
Table 2.
Parameter
Digital Inputs
Digital Output Current
Operating Temperature Range
Storage Temperature Range
Maximum Junction Temperature
Maximum Case Temperature
Rating
−0.3 V to +5 V
20 mA
−40°C to +100°C
−65°C to +150°C
150°C
150°C
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
I.
100% production tested.
II.
100% production tested at 25°C and sample tested at
specified temperatures.
III.
Sample tested only.
IV.
Parameter is guaranteed by design and characterization
testing.
V.
Parameter is a typical value only.
VI.
100% production tested at 25°C; guaranteed by design
and characterization testing.
VII.
Limits defined by HDMI specification; guaranteed by
design and characterization testing.
VIII.
Guaranteed by design.
ESD CAUTION
Rev. 0 | Page 4 of 8
ADV7520
TERMINOLOGY
480i, 480p, 576i, 576p, 720p, 1080i, 1080p
I2C
Common video modes—refer to EIA/CEA-861-D for more
information.
Inter-IC Communications is a Philips two-wire serial bus for
low speed (up to 400 kHz) data.
VGA, SVGA, XGA, SXGA, UXGA
I2S
Common graphics modes—refer to www.VESA.org for more
information.
Inter-IC Sound is a serial Philips bus designed specifically
for audio.
CEC
Consumer electronics control is used to unify remotes of
differing make to perform a given task with one-button touch.
LPCM
DDC
Linear pulse code modulation is a method of encoding audio
samples.
Display data channel is used to communicate between to the
source and sink to determine sink capabilities. It is also used as
the HDCP key communications channel.
RGB
DDR
Red, green, blue is the standard definition for three-color
graphics and video.
Double data rate clocks capture data on both the rising and
falling edge of the clock.
TMDS
EDID
Transition minimized differential signaling is the format used
by the three data channels in HDMI. This encodes eight bits
into 10 bits and serializes them.
Extended display identification is used to store monitor (sink)
capabilities in an EEPROM.
HBR
x.v.Color
High bit rate audio is used to define sample rates greater
than 192 kB.
This is feature of HDMI v.1.3 in which the color gamut can be
extended or altered beyond the normal range to accommodate a
given sink.
HDCP
YCrCb
High bandwidth digital content protection is a method of
protecting content from unauthorized digital copying.
HDMI
This is a common color format for video where the Y component
is luminance and the Cr and Cb signals are color difference
signals. 4:4:4 defines a Y, Cr, and Cb for each pixel; 4:2:2 defines
a Y for each pixel and a sharing of Cr and Cb between two
sequential pixels. In this manner, compression of 33% is possible.
High-Definition Multimedia Interface is composed of three
TMDS differential data channels and one differential clock
channel. It is defined to include video streams up to 3.7 Gbps
as well as audio.
Rev. 0 | Page 5 of 8
ADV7520
APPLICATIONS INFORMATION
DESIGN RESOURCES
DOCUMENT CONVENTIONS
The following resources, as well as evaluation kits, reference design
schematics, and other support documentation, are available
after signing an NDA available from [email protected].
Users can access a programming guide, a hardware user guide, a
software driver user guide, and software driver source code
after signing an NDA.
In this data sheet, data is represented using the conventions
described in Table 3.
Other references include the following:
EIA/CEA-861-D, a technical specifications document, describes
audio and video InfoFrames, as well as the E-EDID structure for
HDMI. It is available from the Consumer Electronics
Association (CEA).
Table 3. Document Conventions
Data
Type
0xNN
0bNN
NN
Bit
High-Definition Multimedia Interface Specification Version 1.3, a
defining document for HDMI v.1.3, and the High-Definition
Multimedia Interface Compliance Test Specification Version 1.3a
are available from HDMI Licensing, LLC.
High-Bandwidth Digital Content Protection System Revision 1.3, the
defining technical specifications document for the HDCP v.1.3, is
available from Digital Content Protection, LLC.
Rev. 0 | Page 6 of 8
Format
Hexadecimal (Base 16) numbers are represented using
the C language notation, preceded by 0x.
Binary (Base 2) numbers are represented using the C
language notation, preceded by 0b.
Decimal (Base 10) numbers are represented using no
additional prefixes or suffixes.
Bits are numbered in little endian format; that is, the
least significant bit of a byte or word is referred to as Bit 0.
ADV7520
OUTLINE DIMENSIONS
9.00
BSC SQ
0.60 MAX
8.75
BSC SQ
TOP
VIEW
*4.85
4.70 SQ
4.55
(BOTTOM VIEW)
33
32
PIN 1
INDICATOR
16
17
7.50
REF
0.80 MAX
0.65 TYP
0.05 MAX
0.02 NOM
0.50 BSC
0.20 REF
*COMPLIANT TO JEDEC STANDARDS MO-220-VMMD-4
EXCEPT FOR EXPOSED PAD DIMENSION
063006-B
SEATING
PLANE
1
EXPOSED PAD
0.50
0.40
0.30
12° MAX
64
49
48
PIN 1
INDICATOR
1.00
0.85
0.80
0.30
0.25
0.18
0.60 MAX
Figure 3. 64-Lead Lead Frame Chip Scale Package [LFCSP_VQ]
9 mm × 9 mm Body, Very Thin Quad
(CP-64-1)
Dimensions shown in millimeters
ORDERING GUIDE
Model
ADV7520BCPZ-801
ADV7520/PCBZ1
1
Temperature Range
−25°C to +85°C
Package Description
64-Lead Lead Frame Chip Scale Package [LFCSP_VQ]
Evaluation Board
Z = RoHS Compliant Part.
Rev. 0 | Page 7 of 8
Package Option
CP-64-1
ADV7520
NOTES
Purchase of licensed I2C components of Analog Devices or one of its sublicensed Associated Companies conveys a license for the purchaser under the Philips I2C Patent
Rights to use these components in an I2C system, provided that the system conforms to the I2C Standard Specification as defined by Philips.
©2008 Analog Devices, Inc. All rights reserved. Trademarks and
registered trademarks are the property of their respective owners.
D07349-0-5/08(0)
Rev. 0 | Page 8 of 8
Similar pages