MINIATURE RELAY 2 POLES—1 to 2 A (FOR SIGNAL SWITCHING) A SERIES RoHS compliant n FEATURES l l l l l l l l l Extremely low profile and light weight —Height: 5 mm —Weight: approximately 1.2 g Meet FCC (Part 68) standard Conforms to FCC rules and regulations part 68 —Surge strength 1,500 V High reliability—bifurcated contacts Wide operating range DIL pitch terminals Plastic sealed type Latching version available RoHS compliant since date code: 0437B8 Please see page 7 for more information n ORDERING INFORMATION [Example] A (a) L – D (b) (*) (c) 12 (d) W – K (e) (f ) - HA (g) (a) Series Name A : A Series (b) Operation Function Nil : Standard type L : Latching type (c) Number of Coil Nil : Single winding type D : Double winding type (d) Nominal Voltage Refer to the COIL DATA CHART (e) Contact W : Bifurcated type (f ) Enclosure K : Plastic sealed type (g) Coil Sensitivity Nil : Standard HA : 75% must voltage operate Note: Actual marking omits the hyphen (-) of (*) 1 A SERIES n COIL DATA CHART Standard Type MODEL Nominal voltage Coil resistance (±10%) Must operate voltage*1 Must release voltage*1 Nominal power A-1.5W-K 1.5 VDC 16.1Ω +1.13 VDC +0.15 VDC 140 mW A- 3 W-K 3 VDC 64.3Ω +2.25 VDC +0.3 VDC 140 mW A-4.5W-K 4.5 VDC 145Ω +3.38 VDC +0.45 VDC 140 mW A- 5 W-K 5 VDC 178Ω +3.75 VDC +0.5 VDC 140 mW A- 6 W-K 6 VDC 257Ω +4.5 VDC +0.6 VDC 140 mW A- 9 W-K 9 VDC 579Ω +6.75 VDC +0.9 VDC 140 mW A-12 W-K 12 VDC 1,028Ω +9.0 VDC +1.2 VDC 140 mW A-18 W-K 18 VDC 1,620Ω +13.5 VDC +1.8 VDC 200 mW A-24 W-K 24 VDC 2,880Ω +18.0 VDC +2.4 VDC 200 mW A-48 W-K 48 VDC 7,680Ω +36.0 VDC +4.8 VDC 300 mW Set voltage*1 Reset voltage*1 Nominal power Note: *1 Specified values are subject to pulse wave voltage. All values in the table are measured at 20°C. Nominal voltage Coil resistance (±10%) Single Winding Latching Type MODEL AL-1.5W-K 1.5 VDC 22.5Ω +1.13 VDC -1.05 VDC 100 mW AL- 3 W-K 3 VDC 90Ω +2.25 VDC -2.1 VDC 100 mW AL-4.5W-K 4.5 VDC 203Ω +3.38 VDC -3.15 VDC 100 mW AL- 5 W-K 5 VDC 250Ω +3.75 VDC -3.5 VDC 100 mW AL- 6 W-K 6 VDC 360Ω +4.5 VDC -4.2 VDC 100 mW AL- 9 W-K 9 VDC 810Ω +6.75 VDC -6.3 VDC 100 mW AL-12 W-K 12 VDC 1,440Ω +9.0 VDC -8.4 VDC 100 mW AL-18 W-K 18 VDC 2,160Ω +13.5 VDC -12.6 VDC 150 mW +18.0 VDC -16.8 VDC AL-24 W-K 24 VDC 3,840Ω AL-D1.5W-K 1.5 VDC P 11.25Ω AL-D 3 W-K 3 VDC AL-D4.5W-K 4.5 VDC Double Winding Latching Type AL-D 5 W-K 5 VDC AL-D 6 W-K 6 VDC AL-D 9 W-K 9 VDC AL-D12 W-K 12 VDC AL-D18 W-K 18 VDC AL-D24 W-K 24 VDC +1.13 VDC S 11.25Ω P S P 45Ω 101Ω P 125Ω 125Ω P 180Ω 180Ω P 405Ω 405Ω P 720Ω S 720Ω P 1,920Ω 200 mW +8.4 VDC +13.5 VDC 300 mW +12.6 VDC +18.0 VDC S 1,920Ω Note: *1 Specified values are subject to pulse wave voltage. All values in the table are measured at 20°C. 200 mW +6.3 VDC +9.0 VDC S 1,080Ω 200 mW +4.2 VDC +6.75 VDC S 200 mW +3.5 VDC +4.50 VDC S 200 mW +3.15 VDC +3.75 VDC S 200 mW +2.1 VDC +3.38 VDC S P 1,080Ω +1.05 VDC +2.25 VDC 45Ω 101Ω 150 mW 200 mW 300 mW +16.8 VDC P: Primary coil S: Secondary coil A SERIES n SPECIFICATIONS Item Contact Coil Time Value Life Other Standard Type Single Winding Latching Type Double Winding Latching Type A-( ) W-K AL-( ) W-K AL-D ( ) W-K Arrangement 2 form C (DPDT) Material Gold overlay silver alloy Resistance (initial) Maximum 50 mΩ (at 1 A 6 VDC) Rating (resistive) 0.5 A 125 VAC or 1 A 30 VDC Maximum Carrying Current 2A Maximum Switching Power 62.5 AV/30 W Maximum Switching Voltage 125VAC, 110VDC Maximum Switching Current 2A Minimum Switching Load*1 0.01 mA 10 mVDC Capacitance Approximately 0.5 pF (between open contacts, adjacent contacts) Approximately 1.0 pF (between coil and contacts) Nominal Power (at 20°C) 140 to 300 mW 100 to 150 mW Operate Power (at 20°C) 80 to 170 W 60 to 85 mW Operating Temperature –40°C to +85°C (no frost) (refer to the CHARACTERISTIC DATA) Operate (at nominal voltage) Maximum 6 ms Maximum 6 ms (set) Release (at nominal voltage) Maximum 4 ms Maximum 6 ms (reset) Mechanical 1 × 108 ops. minimum 1 × 107 ops. minimum Electrical 2 × 105 ops. min. (0.5 A 125 VAC), 5 × 105 ops. min. (1 A 30 VDC) Vibration Misoperation Resistance Endurance 10 to 55 Hz (double amplitude of 3.3 mm) 200 to 300 mW 150 to 170 mW 10 to 55 Hz (double amplitude of 5.0 mm) Shock Misoperation Resistance Endurance 500 m/s2 (11 ±1 ms) 1,000 m/s2 ( 6 ±1 ms) Weight Approximately 1.2 g *1 Minimum switching loads mentioned above are reference values. Please perform the confirmation test with the actual load before production since reference values may vary according to switching frequencies, environmental conditions and expected reliability levels. n INSULATION Item Resistance (initial) Minimum 1,000 MΩ (500VDC) Dielectric Strength open contacts 1,000 VAC 1 min. coil and contacts adjacent contacts 1,000 VAC 1 min. Surge Voltage 1500V (coil-contact) (10/160 µs standard wave) n SAFETY STANDARD AND FILE NUMBERS Type Compliance Contact rating UL UL 478, UL 508 E 45026 Flammability: UL 94-V0 (plastics) 0.5A, 125VAC (General use) 2A, 30VDC (resistive) 0.3A, 110VDC (resistive) CSA C22.2 No. 14 LR 35579 A SERIES n CHARACTERISTIC DATA 0.1 0.3 0.5 n REFERENCE DATA A SERIES A SERIES n DIMENSIONS l Dimensions l Schematics (Bottom View) A, AL type (Non-latching type, single winding latching type) l PC board mounting hole layout (Bottom View) AL-D type (Double winding latching type) Unit: mm A SERIES RoHS Compliance and Lead Free Relay Information 1. General Information Relays produced after the specific date code that is indicated on each data sheet are lead-free now. Most of our signal and power relays are lead-free. Please refer to Lead-Free Status Info. (http://www.fujitsu.com/us/downloads/MICRO/fcai/relays/lead-free-letter.pdf) l Lead free solder paste currently used in relays is Sn-3.0Ag-0.5Cu. l All signal and most power relays also comply with RoHS. Please refer to individual data sheets. Relays that are RoHS compliant do not contain the 5 hazardous materials that are restricted by RoHS directive (lead, mercury, chromium IV, PBB, PBDE). l It has been verified that using lead-free relays in leaded assembly process will not cause any problems (compatible). l “LF” is marked on each outer and inner carton. (No marking on individual relays). l To avoid leaded relays (for lead-free sample, etc.) please consult with area sales office. l We will ship leaded relays as long as the leaded relay inventory exists. Note: Cadmium was exempted from RoHS on October 21, 2005. (Amendment to Directive 2002/95/EC) l 2. Recommended Lead Free Solder Profile l Recommended solder paste Sn-3.0Ag-0.5Cu. Reflow Solder condition Flow Solder condition: Pre-heating: Soldering: maximum 120˚C dip within 5 sec. at 260˚C soler bath Solder by Soldering Iron: Soldering Iron Temperature: maximum 360˚C Duration: maximum 3 sec. We highly recommend that you confirm your actual solder conditions 3. Moisture Sensitivity l Moisture Sensitivity Level standard is not applicable to electromechanical realys. 4. Tin Whisker l Dipped SnAgCu solder is known as low risk tin whisker. No considerable length whisker was found by our in house test. A SERIES Fujitsu Components International Headquarter Offices Japan Fujitsu Component Limited Gotanda-Chuo Building 3-5, Higashigotanda 2-chome, Shinagawa-ku Tokyo 141, Japan Tel: (81-3) 5449-7010 Fax: (81-3) 5449-2626 Email: [email protected] Web: www.fcl.fujitsu.com Europe Fujitsu Components Europe B.V. Diamantlaan 25 2132 WV Hoofddorp Netherlands Tel: (31-23) 5560910 Fax: (31-23) 5560950 Email: [email protected] Web: emea.fujitsu.com/components/ North and South America Fujitsu Components America, Inc. 250 E. Caribbean Drive Sunnyvale, CA 94089 U.S.A. Tel: (1-408) 745-4900 Fax: (1-408) 745-4970 Email: [email protected] Web: http://www.fujitsu.com/us/services/edevices/components/ Asia Pacific Fujitsu Components Asia Ltd. 102E Pasir Panjang Road #01-01 Citilink Warehouse Complex Singapore 118529 Tel: (65) 6375-8560 Fax: (65) 6273-3021 Email: [email protected] Web: http://www.fujitsu.com/sg/services/micro/components/ ©2008 Fujitsu Components America, Inc. All rights reserved. All trademarks or registered trademarks are the property of their respective owners. Fujitsu Components America or its affiliates do not warrant that the content of datasheet is error free. In a continuing effort to improve our products Fujitsu Components America, Inc. or its affiliates reserve the right to change specifications/datasheets without prior notice. Rev. January 9, 2008.