AM-/AMC-132 High Performance Amplifier, 10 dB Gain, 5 - 200 MHz Features n n n V 4.00 FP-8 +49 dBm Typical Midband Third Order Intercept +29 dBm Typical Midband 1 dB Compression 4.5 dB Typical Midband Noise Figure Description M/A-COM’s AM-132 is a coupler feedback amplifier with high intercept and compression points. The use of coupler feedback minimizes noise figure and current in a high intercept amplifier. This amplifier is packaged in a flatpack with flanges. Due to the internal power dissipation the thermal rise should be minimized. The ground plane on the PC board should be configured to remove heat from under the package. AM-132 is ideally suited for use where a high intercept, high reliability amplifier is required. C-25 Absolute Maximum Ratings 1 Parameter Absolute Maximum Max. Input Power +15 dBm Vbias +17.0 V Operating Temperature -55°C to +85°C Storage Temperature -65°C to +125°C 1. Operation of this device above any one of these parameters may cause permanent damange. Pin Configuration Pin # Function Pin # Function 1 RF OUT 6 RF IN 2 GND 7 GND 3 GND 8 GND 4 GND 9 GND 5 Vbias 10 GND High Performance Amplifier, 10 dB Gain, 5 - 200 MHz AM-/AMC-132 V 4.00 Electrical Specifications2 TA = -55°C to +85°C Case Temperature Parameter Test Conditions Frequency Units Min. Typ. Max. Gain 50 MHz @ +25°C 50 MHz dB 9.5 10.0 10.5 Frequency Response — 5 - 200 MHz dB — — ±0.5 Gain Variation with Temperature — 5 - 200 MHz dB — — ±0.6 1 dB Compression Output Power 5 - 200 MHz dBm +25 — — Noise Figure — 5 - 200 MHz dB — — 6.0 Reverse Transmission — 5 - 200 MHz dB — -14 -13 VSWR — 5 - 200 MHz Ratio — — 1.5:1 Output IP2 Two-tone inputs up to +10 dBm 5 - 200 MHz dBm +54 — — — — Output IP3 Two-tone inputs up to +10 dBm 5 - 200 MHz 5 - 70 MHz dBm dBm +38 +45 — — — — Vbias — — V 14.25 15 15.75 Ibias Vbias = +15.0 VDC — mA — 90 110 Power Dissipation @ +15V Bias — W — 1.35 — 2. All specifications apply when operated at +15 VDC, with 50 ohms source and load impedance. 3. Heat Sinking: Operation at case temperature above 95°C is not recommended. Heat sinking adequate to dissipate 1.75W must be provided in use. Typical Performance Curves Gain vs. Frequency Intermodulation Intercept +25°C -55°C IP3 Intercept (dBm)IP2 Gain (dB) 11.0 10.5 10.0 9.5 IP2 68 52 66 50 64 48 62 46 60 3 5 10 20 50 100 200 300 Frequency (MHz) Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. Intercept (dBm) IP3 +85°C 44 3 5 10 20 50 100 200 300 Frequency (MHz) 2 High Performance Amplifier, 10 dB Gain, 5 - 200 MHz AM-/AMC-132 V 4.00 Typical Performance Curves VSWR vs. Frequency Noise Figure and 1 dB Compression Noise Figure (dB) VSWR 1.75 1.50 1.25 1.00 Noise Figure 5.5 31 5.0 30 4.5 29 4.0 3 5 10 20 50 100 200 300 Frequency (MHz) Output Power (dBm) Output Power RF OUT RF IN 2.00 28 3 5 10 20 50 100 200 300 Frequency (MHz) Ordering Information Part Number Package AM-132 PIN FP-9 AMC-132 SMA C-25 Specifications subject to change without notice. n North America: Tel. (800) 366-2266 n Asia/Pacific: Tel.+81-44-844-8296, Fax +81-44-844-8298 n Europe: Tel. +44 (1344) 869 595, Fax+44 (1344) 300 020 Visit www.macom.com for additional data sheets and product information. 3