MENB1080 - SL Power Electronics

MENB1080
Universal Input 80 Watt Series
Medical Switch-Mode Power Supply
3 Year Warranty
•100-240VAC Universal Input
•Meets EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
•Desktop Style
•12V to 24V Single Output Models, up to 80W
•Modified and Custom Designs Available
•Regulated Output with Low Ripple
•Impact-Resistant Polycarbonate Enclosure
•No Load Power Consumption <0.5W
•Certified to UL/EN/IEC60601-1, 3
rd
Edition
RoHS
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.
Specifications
AC Input
Input Current
100-240Vac, +/-10%, 47-63 Hz, 1∅
100Vac: 1.5A
Inrush Current
Input Fuse
60A peak @ 264Vac, cold start
3.15A, 250V Internal Primary Current Fuse provided
Efficiency
Meets International Efficiency Level V
MTBF
Hold-up Time
Overload Protection
Topology
See chart
Safety and EMC Approvals
Output Power
See chart
Dielectric Withstand
Line/Load Regulation
1% pk-pk max., 20MHz BW
Line: +/- 1 to 2%, Load: +/-5% at end of cable
Transient Response
500μs max., 50% load step, typical
Minimum Load
Not required
Case Material
Case Dimensions
Black 94V0 Polycarbonate
131 x 72 x 43mm See outline drawing
Hiccup Mode
Short Circuit Protection
Output Voltage
Ripple and Noise
>100,000 hours calculated
18 ms min. @ 115Vac, 60 ms min. @ 230 Vac
Operating Temperature
Storage Temperature
Relative Humidity
Hiccup Mode
Switching – Fixed Frequency Flyback
EN/IEC/CSA/UL60601-1, 3rd Edition
EMC: See chart
Input-Output: 2 MOOP
Input-GND: 1 MOOP, Output-GND: 500Vdc
0° to 40°C, no derating
-30 to +85°C
5% to 95%, non-condensing
Altitude
0 to 10,000 ft
Output Connections
Cable: 20AWG, 1,800mm, 4 conductor
Connector: Ault #3, 2.5mm barrel or #51, 6-pin Molex (12V model)
Weight
500g
EMI/EMC Compliance
Conducted Emissions
FCC Part 15, Class B, EN55011 Class B, EN55024
Radiated Emissions
FCC Part 15, Class B, EN55011 Class B, EN55024
Voltage Fluctuations
EN61000-3-3, Line Flicker
Static Discharge Immunity
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
Radiated RF Immunity
EN61000-4-3, 3V/m.
EFT/Burst Immunity
EN61000-4-4, 2kV/5kHz..
Line Surge Immunity
EN61000-4-5, 1kV differential, 2kV common-mode
Conducted RF Immunity
EN61000-4-6, 3Vrms
Power Frequency Magnetic Field Immunity
EN61000-4-8, 3A/m
Voltage Dip Immunity
EN61000-4-11 crit. A, 100Vac 60Hz, 40%/5 cycles with 70% full load.
Line Frequency Harmonics
EN61000-3-2, Class A
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com
MENB1080
Universal Input 80 Watt Series
Medical Switch-Mode Power Supply
Model Number
3 Year Warranty
Volts (V)
Output Current (max)
Max Watts
Ripple (Vp-p max)
MENB1080A1251F01
12 V
6.5 A
78.0 W
120mV
MENB1080A1503F01
15 V
5.2 A
78.0 W
150mV
MENB1080A1803F01
18 V
4.33 A
78.0 W
180mV
MENB1080A2403F01
24 V
3.25 A
78.0 W
240mV
Model Number Key
MENB 1 080 A VV 03 F 01
Model
Input Connector:
Output Connector:
Output Voltage:
Model
Output Pow er:
# of Outputs
Product Fam ily:
"01" = Standard. "02" and higher indicates a m odified m odel.
"F" = IEC320 C14 grounded, Other options available, see below
"03" = 2.5m m Barrel Type Connector, "51" = 6 pin Molex. Other options available.
"05" = 5Vdc, "12" = 12Vdc, "24" = 24Vdc, etc.
"A" = Original Configuration
"080" = 80 Watts
"1" = Single Output
"M" = Medical, "E" = External, "NB" = Model Series Designator
Output Connector
Output Connector (12V Model)
“#3” Connector is 2.5mm barrel type, center (+)
“#51” Connector is Molex 39-01-2060 or equivalent.
Input Receptacle
IEC320 C14 - Class I
Grounded (F)
"51" Connector Pinout: Pins 1, 4: (+), Pins 3, 6: (-). Mate = Molex 39-01-2061 or equiv.
Outline Drawing
Ault #3 connector shown.
Dimensions are in mm
Data Sheet © 2015 SL Power Electronics Corp. The information and specifications contained herein are believed to be correct at the time of publication.
Rev. 8-11-2015
However, SL Power accepts no responsibility for consequences arising from reproduction errors or inaccuracies. Specifications are subject to change without notice.
______________________________________________________________________________________________________________________________ 2 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone 805.486.4565 • Fax 858.712.2040 • Email: [email protected] • www.slpower.com