RoHS M1-M7 SURFACE MOUNT SILICON RECTIFIER D T SMA FEATURES . 0 7 8 (2.0) .096(2.44) Open . Junction Chip ,. L For surface mounted appllcations Low leakage .055(1.4) .062(1.6) High forward surge current capability. .188(4.8) .208(5.28) High termperatore soldering guaranteed: o 260 C/10 secondsat terminals O .002(0.051) .008(0.203) MECHANICAL DATA C .006(0.152) .012(0.152) .030(0.76) .060(1.52) Case: Transfer molded plastic Epoxy: ULA4V-0 rate flame retardent. Polarity: Color band denotes cathide end Lead: Plated axial lead ,solderable per MIL-STD-202E method 208C Weight: 0.002 ounce,0.057 gram O R T IC N .157(4.0) .181(4.6) .098(2.5) .114(2.9) Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS o Ratings at 25 Cambient temperature unless otherwise specified. Single phase,half wave,60Hz,resistive or inductive load. For capacitive load derate current by 20%. C E L Maximum Repetitive Peak Reverse Voltage Maximum RMS Voltage SYMBOLS E Peak Forward Surge Current 8.3ms single half sine-wave superimposed on J E M2 M3 M4 M5 M6 M7 UNITS V RRM 50 100 200 400 600 800 V RMS 35 50 70 140 280 420 560 1000 V olts 700 V olts 100 200 400 600 800 1000 V olts V DC Maximum DC Blocking Voltage Maximum Average Forward Rectified Current o at T A =75 C M1 I (AV) 1.0 A mps I FSM 30 A mps rated load (JEDEC Method) Maximum Instantaneous Forward Voltage at Drep 1.0A Maximum DC Reverse Current at rated DC blocking voltage W o T A =25 C o T A =125 C Maximum Full Load Reverse Current,full cycle o average at T A =75 C Typical Junction Capacitance(NOTE1) Typical Thermal Resistance(NOTE2) Operating and Storage Temperature Range 1.1 VF V olts 5.0 IR R JA CJ R A 50 JA T J ,T STG A 30 pF 15 30 O C/W -65 to +175 NOTES: 1.Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts. 2. .24in22(6.0mm 2)copper pads to each terminal. WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] O C RoHS FIG.1-TYPICAL FORWARD CURRENT FIG.2-MAXIMUM NON-REPETITIVE PEAK DERATING CURVE FORWARD SURGE CURRENT 1.0 0.8 0.6 Single Phase Half Wave 60Hz 0.4 Resistive or Inductive Load 0.2 0.375 ＂(9.5mm) Lead Length 0 0 25 50 75 100 125 150 30 (JEDEC Method) T j=Tjmax 20 10 1 Cycle 175 0 o AMBIENT TEMPERATURE,( C) 1 2 C 4 6 8 10 20 40 60 80100 NUMBER OF CYCLES AT 60 Hz IC FIG.3-TYPICAL INSTANTANEOUS FIG.4-TYPICAL REVERSE FORWARD CHARACTERISTICS N CHARACTERISTICS 10 o Tj=25 C Pulse width=300 s 1% duty cycle C E L 0.1 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 O 1.0 1.8 E 0.1 o Tj=25 C 0.01 0 20 40 60 80 100 120 PERCENT OF RATED PEAK INSTANTANEOUS FORWARD VOLTAGE,(V) J E o Tj=100 C (uA) R T 1.0 INSTANTANEOUS REVERSE CURRENT, 10 (A) INSTANTANEOUS FORWARD CURRENT, D T ,. L O 8.3ms Single Half Sine-Wave CURRENT,(A) PEAK FORWARD SURGE 1.2 (A) AVERAGE FORWARD CURRENT, M1-M7 REVERSE VOLTAGE,(%) FIG.5-TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE,(pF) 100 W 10 o Tj=25 C f=1MHz Vsig=50mVp-p 1 0.1 1.0 10 100 REVRESE VOLTAGE,(V) WEJ ELECTRONIC CO. Http:// www.wej.cn E-mail:[email protected] 140