VER : A_4 update : 2015.05.15 LED Power PLF16 SERIES 16 Watts KEY FEATURES Fully Isolated Plastic Case with IP65 Level Constant Current Universal Input: 90-264 VAC With P.F.C. Function, PF>0.93 High Efficiency up to 86% Turn-on Delay < 250ms Protections: Over Load / Over Voltage / Short Circuit .Over Temperature(optional) High Reliability & Double Layered PCB 3-Years Product Warranty ELECTRICAL SPECIFICATIONS All specifications valid at normal input voltage, full load and +25°C after warm-up time unless otherwise stated. Model No. Max output wattage (W) Voltage Input Output Protection Isolation Environment Physical Safety & EMC (Note1) PLF16-1050 PLF16-700 PLF16-350 16.38W 16.8W 16.8W 90-264 VAC Frequency (Hz) 47~63 Hz Power factor PF>0.93 at full load (115/230 VAC) Current (full load) 0.6A max. (115 VAC) / 0.3A max. (230 VAC) Inrush current 40 A max. (Cold Start at 230 VAC) Leakage current <0.25mA Voltage (V.DC.) (max) 15.6V 24V 48V Operation Voltage (Note2) 11~15.6VDC 16.8~24VDC 33.6~48 VDC Current (mA) 1050 700 350 86% 86% Load Regulation (Min-Max) (typ.) ±4% Ripple & Noise (max) (Note3) 3Vp-p Current Regulation (at 230VAC) (Note4) ±5% Efficiency (typ) (at 230VAC) 84% Over Temperature protection(optional) Auto recovery Over voltage protection Auto recovery Short circuit protection Auto recovery Input-Output (V.AC) 4000V Operating temperature -30°C…+70°C (with derating) Storage temperature -40°C…+85°C Temperature coefficient 0.1%/°C Humidity 95% RH MTBF >906,500 h @ 25°C (MIL-HDBK-217F) Dimension (L x W x H) 3.47 x 1.69 x 1.1 Inches Weight 150 g Cooling method Free air convection Safety Standards EN61347-1、EN61347-2-13 EMI (Conducted & Radiated Emission) EN 55015 EMS (Noise Immunity) EN 61547 http://www.archcorp.com.tw TEL: +886-2-26989508 FAX: +886-2-26981319 ( 88.0 x 43.0 x 28.0 mm ) Tolerance 0.5 mm -1- VER : A_4 update : 2015.05.15 LED Power PLF16 SERIES 16 Watts Note: 1. Please check the derating curve for more details. 2. This is the suitable operation region for LED related application.but please reconfirm special electrical requirements for some specific system design 3. Ripple & Noise are measured at 20MHz of bandwidth with 0.1uF & 47uF parallel capacitor. 4. (1) Current Regulation <±7.5% (at 115VAC Input Voltage) (2)Current Regulation <±10% (at other Input Voltage) 5. Please contact us for more information. 6. It's recommended to add Varistor 14S471K at L / N input side in parallel. 7. This driver is suggested for LED application only. 8. Direct connection to LEDs is suggested. Connecting additional drivers would not be appropriate. MECHANICAL DIMENSION ( Top View ) DERATING http://www.archcorp.com.tw TEL: +886-2-26989508 FAX: +886-2-26981319 -2-