RF AMPLIFIER MODEL TM7101PM Available as: TM7101PM, 4 Pin TO-8 (T4) TN7101PM, 4 Pin Surface Mount (SM3) BX7101PM, Connectorized Housing (H1) Features Typical Intermodulation Performance at 25 ºC ! ! ! ! Second Order Harmonic Intercept Point ....... +41 dBm (Typ.) Second Order Two Tone Intercept Point ........ +35 dBm (Typ.) Third Order Two Tone Intercept Point ............ +30 dBm (Typ.) Low Noise Figure: 1.8 dB Typical High Gain: 27.5 dB Typical Operating Temp. -55 ºC to +85 ºC Environmental Screening Available Absolute Maximum (No Damage) Ratings Specifications CHARACTERISTIC Frequency Gain (dB) Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) VSWR In Out TYPICAL Ta= 25 ºC 10 - 150 MHz 27.5 MIN/MAX Ta = -55 ºC to +85 ºC 10 - 150 MHz 26.0 Min. +16.5 +15.0 Min. -31.5 <1.5:1 <1.25:1 -30 Max. 2.0:1 Max. 2.0:1 Max. 1.8 2.5 Max. +15 20 +15 23 Max. Noise Figure (dB) Power Vdc mA Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature ................................. -62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +18 Volts Continuous RF Input Power .................................. +13 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power .................... 0.5 Watt (3 µsec Max.) Guaranteed @ 25 ºC (80 MHz) Phase Noise Performance (dBc/Hz)* Frequency Typical Guaranteed -155 -150 100 Hz 1 kHz -162 -155 -164 10 kHz -160 100 kHz -164 -160 1 MHz -164 -160 Note: Care should always be taken to effectively ground the case of each unit. *Note: Phase Noise Performance typically tested at midband. Bandedge performance may vary. Typical Performance Data Gain (dB) 29 0 28 - 10 27 - 20 26 25 - 30 +18 Start 10 MHz Stop 150 MHz - 40 -130 - 140 -150 Start 1 0 MHz Stop 150 MHz Noise Figure (dB) 1 dB Comp. (dBm) -180 2 +16 +15 1 Start 10 MHz Stop 150 MHz Input VSWR 2.0 -1 90 100 Start 10 MHz Legend Stop 150 MHz +25 ºC 1.0 10 k 10 0 k 1M Stop 150 MHz * Output VSWR 1.5 Start 1 0 MHz 1k __ __ __ __Typical 2.0 1.5 1.0 -160 -170 3 +17 +14 Phase Noise (dBc/Hz) Reverse Isolation (dB) Start 1 0 MHz Residual Phase Noise Test Conditions Carrie r Frequency: 80 MHz Power Output: +15 dBm Temperature: 25 ºC Agile nt ES5500 System Stop 150 MHz +85 ºC - - - - - - -55 ºC Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 Rev. 8/20/09 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001