A-A-55534/07

[INCH-POUND]
A-A-55534/7B
24 April 2003
SUPERSEDING
A-A-55534/7A
23 December 2002
COMMERCIAL ITEM DESCRIPTION
RESISTORS, FIXED, CHIP, VERY LOW VALUES
(POWER TYPE), STYLE VLV2010
The General Services Administration has authorized the use of this
commercial item description (CID) for all federal agencies.
1. SCOPE. This CID covers the general requirements for style VLV2010 wirewound or metal element,
chip, power type, fixed resistors. The resistors covered by this CID are intended for commercial/industrial
applications.
2. CLASSIFICATION. This CID uses a classification system which is included in the Part Identification
Number (PIN). The PIN shall be AA55534/07- (plus a coded number) as shown in the following example.
F
|
|
Resistance
tolerance
(see 3.3)
NOTE: This PIN has been derived in accordance with A-A-55534.
AA55534/07
|
|
CID number
-
R010
|
|
Resistance value
(see 3.2)
B
|
|
Termination
finish
(see 3.4)
3. SALIENT CHARACTERISTICS.
3.1 Interface and physical dimensions. The resistors supplied to this CID shall meet the interface and
physical dimensions as specified herein (see figure 1).
3.2 Resistance value. The resistance value shall be 0.007 ohm to 0.5 ohm.
3.3 Resistance tolerance. This style resistor is available in resistance tolerances F, H, and J (±1 percent,
±3 percent, and ±5 percent respectively).
3.4 Termination finish. The termination finish shall be identified by a single letter, B for tin/lead (Sn/Pb) (3
percent lead minimum) or T (Sn) (100 percent tin).
3.5 Power rating. The power rating shall be 0.5 watt at +70°C. The power rating shall be linearly derated
to zero at +150°C or +175°C (see 7.5).
Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data which
may improve this document should be sent to: Defense Supply Center, Columbus,
ATTN: DSCC-VAT, PO Box 3990, Columbus, OH 43216-5000, or telephone (614) 692-0553, or
facsimile (FAX) (614) 692-6939.
AMSC N/A
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
FSC 5905
A-A-55534/7A
Inches
mm
Inches
mm
0.010
0.020
0.025
0.25
0.51
0.64
0.100
0.200
2.54
5.08
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. The picturization of the style above is given as representative of the envelope of the item. Slight
deviations from the outline shown, which are contained within the envelope and do not alter the
functional aspects of the device, are acceptable.
FIGURE 1. Resistors, fixed, chip, very low values (style VLV2010).
3.6 Temperature coefficient. The temperature coefficient of resistance shall not exceed ±400ppm/°C
from -55°C to +150°C or 175°C (see 7.5).
3.7 Marking. Resistors supplied to this CID shall be marked with the manufacturers (MFGR) standard
commercial PIN. Marking of individual small devices (e.g. chips) is not required but is permitted;
however, each unit pack supplied to this CID shall be marked with the MFGR standard commercial PIN.
4. REGULATORY REQUIREMENTS. This section is not applicable to this CID sheet.
5. PRODUCT CONFORMANCE PROVISIONS. Product conformance provisions shall be as specified in
A-A-55534.
2
A-A-55534/7A
6. PACKAGING. Packaging shall be as specified in A-A-55534.
7. NOTES.
7.1 PIN. The PIN should be used for Government purposes to buy commercial products to this CID. See
section 2 for PIN format.
7.2 Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and
submission of these resistors to DSCC under the Military Parts Control Advisory Group (MPCAG)
evaluation program, CAGE code 58536 should be used.
7.3 Source of documents.
Commercial Item Description
A-A-55534 - Resistor, Fixed, Power Type (Very Low Resistance Values), General Requirements
For.
(Copies of commercial item descriptions are available from the Document Automation and Production
Service (DAPS), Building 4D (Customer Service), 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
7.4 Ordering data. Ordering data shall be as specified in A-A-55534.
7.5 Commercial products. As part of the market analysis and research effort, this CID was coordinated
with the following MFGR’s of commercial products. At the time of CID preparation and coordination, these
MFGR’s were known to have commercial products that would meet the requirements of this CID. (NOTE:
This information should not be considered as a list of approved MFGR’s or be used to restrict
procurement to only the MFGR’s shown.)
TABLE I. Commercial products.
CID PIN
MFRG CAGE
AA55534/07-******
Resistance value 0.007 ohm to 0.5
ohm, resistance tolerance F, H, and
J, temp coefficient ±75ppm, derated
to zero at 175°C.
Res. value 0.050 ohm to 0.500
ohm, temp coefficient ±100ppm;
res. value 0.020 ohm to 0.049 ohm,
temp coefficient ±300ppm; res.
value 0.010 ohm to 0.019 ohm,
temp coefficient ±400ppm; derated
to zero at 150°C; res. Tol. F, H, and
J.
91637
MFGR name and address
Dale Electronics, Incorporated
rd
1122 23 St.
Columbus, NE 68601-0609
Dale Israel, Ltd.
Emek-Sara Industrial Zone
3, Ha’Kotzer str.
Be’er Sheva, Israel 84 874
57027
3
TT Electronics / IRC
4222 S. Staples St.
Corpus Christi, TX 78411-2702
A-A-55534/7A
7.6 Part number (P/N) supersession data. This CID supersedes the MFGR’s style as shown below. This
information is being provided to assist in reducing proliferation in the Government inventory system.
TABLE II. P/N supersession data.
MFGR's CAGE
MFGR's style 1/
91637
57027
WSL 2010
LR2010
1/ The MFGR's style shall not be used for procurement to
the requirements of this CID. At the time of preparation
of this CID, the aforementioned commercial products
were reviewed and could be replaced by the CID PIN
shown.
7.7 Government users. To acquire information on obtaining these resistors from the Government
inventory system, contact Defense Supply Center, Columbus, ATTN: DSCC-CPBC, PO Box 3990,
Columbus, OH 43216-5000, or telephone (614) 692-7678.
MILITARY INTERESTS:
CIVIL AGENCY COORDINATING ACTIVITY:
Custodian
Navy - EC
DLA-CC
GSA - 7FXE
Preparing Activity:
DLA-CC
Project 5905-1694-02
4
Similar pages