HUCKSPIN SINGLE TOOL CONTROLLER WIRING CHANGE (125725 & 125726) Tool & Product Update The original single tool controller was to have an on-board memory chip in the tool. The memory was never added but the wiring was. If the wire were to short out, the processor thinks there is a memory chip in the the tool, but does not understand the information. This will effect the thimble & anvil counts. To fix this issue you will need to disconnect the white wire from connector J2 position 2 located in the controller housing. Tape the end of the wire, DO NOT REMOVE WIRE, MAY BE USED IN THE FUTURE. (Refer to Figure 1 on page 2) For more information please contact your local AFS representative. PKGNA GRP2, 5, 8, 9, 12, 16, 18, 21 Page 1 of 2 01/20/04 PB533 Page 2 of 2 1 1a 1b 2b 8-PIN RECEPTACLE P/N: 506515 3 1 2 GREEN RED BLACK BLUE GREEN RED WHITE BROWN 8 1 2 7 3 6 5 4 BLACK YELLOW CABLE 4-20AWG P/N: 507438 GREEN 4 WHITE (2) RING TERMINAL P/N: 507469 WIRE, GREEN P/N: 507470 RED WIRE, GREEN P/N: 507470 SQ. FL. RECEPTACLE P/N: 507434 (4) PIN CONTACT P/N: 507435 SWITCH P/N: 507465 2 2a BLACK GREEN 8 7 6 5 4 3 2 1 CABLE 9-20AWG P/N: 505298 5 4 3 2 1 2 1 J2 P/N: 507432 J4 4 3 2 1 P/N: 507429 J3 6 5 4 3 2 1 P/N: 507431 WHITE CABLE 4-20AWG P/N: 507438 RED BLACK GREEN AIR VALVE P/N: 506693 ALARM - AUDIO P/N: 506685 (4) WIRE NUT P/N: 507087 INDICATOR P/N: 119936 (2) RING TERMINAL P/N: 505761 (4) WIRE NUT P/N: 507087 CABLE 4-20AWG P/N: 507438 (+) Fig 2 (2) DISCONNECT P/N: 507466 PRESSURE TRANSMITTER P/N: 507437 J1 P/N: 507430 J10 P/N: 507248 NOT REMOVE WIRE. GREEN (3) RING TERMINAL P/N: 503556 WHITE CABLE 2-22AWG P/N: 507444 DO To fix this issue you will need to disconnect the white wire from connector J2 position 2. Tape the end of the wire. 125725 & 125726 SINGLE TOOL CONTROLLER (+) RED (-) BLACK (-)