PSOC® 3 DEVELOPMENT KIT QUICK START GUIDE 1 2 Remove the PSoC 3 Development Kit from the package. Plug the LCD module into port P8. 3 4 Plug the USB cable into your PC and the onboard programming USB port (J1). Vary the R56 potentiometer. The voltage is displayed with a 20-bit resolution on the LCD module. 5 6 Insert the PSoC 3 Development Kit CD. Install PSoC Creator and the kit software. Launch PSoC Creator. Open the code examples from the Start Page. PSOC® 3 DEVELOPMENT KIT QUICK START GUIDE PSoC 3 Development Kit Details Power Adapter Communication USB 9-V Battery Boost Converter 10-Pin JTAG/SWD/SWO Input Debug and Prog Header Onboard Programming USB 32-kHz Crystal 24-MHz Crystal Port D (CapSense/ Miscellaneous Port) Port E (Analog Port) Reset Button Variable Resistor/ Potentiometer CapSense RS-232 Interface Character LCD Interface Switches/LEDs Prototyping Area For the latest information about this kit, visit http://www.cypress.com/go/CY8CKIT-030 © 2012-2013 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc. #: 001-83885 Rev. *C