PSoC® 5LP DEVELOPMENT KIT QUICK START GUIDE 1 2 Remove the PSoC 5LP Development Kit from the package. Plug the LCD module into port P8. 3 4 Plug the USB cable into your PC and the USB onboard programming port (J1). Vary the R56 potentiometer. The voltage is displayed with a 12-bit resolution on the LCD module. Note: USB port J2 is the PSoC device's USB communications port. USB port J1 is used for program/debug and requires the appropriate software drivers to be installed. 5 6 Insert the PSoC 5LP Development Kit CD. Install PSoC Creator and the kit software. Launch PSoC Creator. Open the code examples from the Start Page. PSoC® 5LP DEVELOPMENT KIT QUICK START GUIDE PSoC 5LP Development Kit Details For the latest information about this kit, visit www.cypress.com/go/CY8CKIT-050 © 2011-2013 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc#: 001-65815 Rev. *E