Rev. 7/10 0.1 TO 8.0 GHz THRESHOLD DETECTOR DTS8003 DTS8003 Typical Values @ +25 °C Wide Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . 0.1 to 8.0 GHz Wide Power Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . -10.0 to +15.0 dBm Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . . ± 0.50 dB Power Flatness. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ± 0.50 dB Standard Size TO-8 or Surface Mount Package External Adjustable Threshold Level, Fast Response Time, Low Drift, Insensitive Threshold Level to Applied Voltage DTC8003 TO-8 Package for Detectors SPECIFICATIONS* Parameter Typical Frequency (Min.) Guaranteed 0 to 50 °C -40 to +85 °C 0.1-9.0 GHz 0.1-8.0 GHz 0.1-8.0 GHz -10 to +15 dBm* -5 to +15 dBm* -5 to +15 dBm* 1.2:1 1.7:1‡ 1.7:1‡ Power Flatness (Max.) ±0.5 dB ±0.75‡ dB ±0.75‡ dB Threshold Temperature Stability (Max.) ±0.25 dB ±0.5 dB ±0.5 dB Threshold Hysteresis (Max.) ±0.2 dB ±0.5 dB ±0.5 dB Pulse Response (Max.) 50^ µsec 100^ µsec 100^ µsec 1 1 1 Output Voltage Hi @ 5mA source 4.4 Volts 3.5 Volts 3.5 Volts Output Voltage Lo @ 5mA sink 0.1 Volts 0.25 Volts 0.25 Volts 1.0 mA 2.0 mA 2.0 mA Input Power Range (Min.) VSWR (Max.) Logic: Pin > Pth Supply Current (Max.) DTS8003 * Measured in a 50 Ohm system at Vs=+5.0 Vdc. RTH=100 ohm to 100 KOhm unless otherwise specified. ^ 50% RF to 10 or 90% Video Response time for input change 3 dB above Pth. ‡ For TO-8 model (DTC8003) VSWR degraded to 2.0:1 above 4 GHz and flatness degraded to ±1.0 dB above 7 GHz. SMTO-8 Package for Detectors MAXIMUM RATINGS DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Continuous RF Input Power . . . . . . . . . . . . . . . . . . . . . Operating Case Temperature . . . . . . . . . . . . . . . . . . . . Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . Detector Thermal Resistance1 (θjc) . . . . . . . . . . . . . . . Temperature Rise @ 0 dBm . . . . . . . . . . . . . . . . . . . . . 1 Thermal +15 V +20.0 dBm -40 °C to +125 °C -65 °C to +150 °C +125 °C +3500 °C/Watt +3.5 °C resistance is based on RF input power. Ratings based on +25 °C. APPLICATION NOTES This unit is DC coupled and employs a RF choke at the input (DC short). DO NOT bypass the Threshold Control pin. Capacitance greater than 50pF may cause instabilities. Keep the threshold programming resistor or circuit close to this pin. Average power detection is obtained at power levels below approximately +7 dBm. The output of this unit is derived from an op-amp, not a true logic device. Connect external threshold resistor from Rcntl port to ground. DIMENSIONS ARE IN INCHES [MILLIMETERS] 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected] DTS8003 R TYPICAL PERFORMANCE Input VSWR @ Pin = +10 dBm -1.0 1.6 -2.0 1.5 -3.0 1.4 VSWR RF INPUT - dBm Threshold Power @ R = 100 KEY: +25 °C +85 °C Ohms -40 °C -4.0 1.3 1.2 -5.0 1.1 -6.0 0.1 0.5 1.0 1.5 2.0 3.0 4.0 5.0 6.0 7.0 FREQUENCY - GHz 8.0 8.5 9.0 9.5 10.0 1.0 0.1 1.0 Threshold Power @ R = 1 KOhms 2.0 2.5 3.0 3.5 4.0 4.5 5.0 5.5 FREQUENCY - GHz 6.0 6.5 7.0 7.5 8.0 1 6.0 5.0 Hysterisis Vs Input Power @ 25° C 0 -0.1 4.0 + 3.0 2.0 0.1 0.5 1.0 1.5 2.0 3.0 4.0 5.0 6.0 7.0 FREQUENCY - GHz 8.0 8.5 9.0 9.5 10.0 HYSTERISIS - dB RF INPUT - dBm 7.0 -0.2 -0.3 -0.4 -0.5 Threshold Power @ R = 20 KOhms -0.6 RF INPUT - dBm 16.0 -20 -15 -10 -5 0 5 INPUT POWER - dBm 10 15.0 14.0 13.0 12.0 11.0 0.1 0.5 1.0 1.5 2.0 3.0 4.0 5.0 6.0 7.0 FREQUENCY - GHz 8.0 8.5 9.0 9.5 10.0 Pulse Response @ RTH =100 Ohms R Pulse Response @ RTH = 1 KOhms Pulse Response @ RTH = 20 KOhms Top Trace: TTL Logic Out Bottom Trace: RF Input Time Base: 10.0 µs/div 650-691-9800 • Fax: 650-962-6845 • Updates: www.teledynemicrowave.com • [email protected] 15 20