NCP3337MN180GEVB_TEST_PROCEDURE.PDF

Test Procedure for NCP3337 1V8 DFN10 LDO Demoboard
Test procedure:
1.Check the position of jumper and correct it if necesary.
a)PWRGSUPP
- ON
b)EXT/INT
- INT
c)ON/OFF
- ON
2. Connect the test setup as shown Figure
3. Appy an input voltage Vin = 2.9 V
4. Appy Iout = 0mA load.
5. Check that Vout is 1.8 V.
6. Increase Iout up to 500 mA
7. Check the voltage at PWRG pin Upwrg = Vin
7. Increase Vin up to 12 V and decrease the load in accordance with SOA
8. Power down the Load
9. Power down the Vcc
10. End of test

Open as PDF

Similar pages: NCP3337MN500GEVB_TEST_PROCEDURE.PDF - 1218.0 KB; NCP3337MN330GEVB_TEST_PROCEDURE.PDF - 1218.0 KB; NCP3337MN250GEVB_TEST_PROCEDURE.PDF - 1220.0 KB; NCP3337MNADJGEVB_TEST_PROCEDURE.PDF - 1144.0 KB; NCV8537MN180GEVB_TEST_PROCEDURE.PDF - 946.0 KB; NCV8537MNADJGEVB_TEST_PROCEDURE.PDF - 651.0 KB; NCV8537MN500GEVB_TEST_PROCEDURE.PDF - 1186.0 KB; NCV8537MN330GEVB_TEST_PROCEDURE.PDF - 946.0 KB; NCV8537MN250GEVB_TEST_PROCEDURE.PDF - 946.0 KB; NCP571SN10T1GEVB_TEST_PROCEDURE.PDF - 251.0 KB; NCP571SN09T1GEVB_TEST_PROCEDURE.PDF - 248.0 KB; NCP571SN08T1GEVB_TEST_PROCEDURE.PDF - 248.0 KB; NCP571MN12TBGEVB_TEST_PROCEDURE.PDF - 1168.0 KB; NCP571MN10TBGEVB_TEST_PROCEDURE.PDF - 1164.0 KB; NCP571MN09TBGEVB_TEST_PROCEDURE.PDF - 1166.0 KB; NCP571MN08TBGEVB_TEST_PROCEDURE.PDF - 1158.0 KB; NCP3337MN330GEVB_SCHEMATIC.PDF - 560.0 KB; NCP3337MN250GEVB_SCHEMATIC.PDF - 559.0 KB; NCP170AMX300GEVB_TEST_PROCEDURE.pdf - 36 KB; NCP715MXTBGEVB_TEST_PROCEDURE.PDF - 78.0 KB; NCP715SQT2GEVB_TEST_PROCEDURE.PDF - 74.0 KB; NCP3337MN250GEVB_BOM_ROHS.PDF - 573.0 KB

NCP3337MN180GEVB_TEST_PROCEDURE.PDF - 684.0 KB