CY4605 EZ-USB® HX2LP™ REFERENCE DESIGN KIT QUICK START GUIDE 1 2 Insert the kit CD/DVD into the CD/DVD drive of your PC. Review kit contents. Place jumper on J5 (power status) and J6 (port status) to enable LEDs D1 and D3-D6. Power LED D1 glows only in self-powered mode. The green LEDs (D3 and D5) indicate that the downlink port is enabled. The amber LEDs (D4 and D6) indicate the port has an exception condition. 3 4 Plug the wall mounted power supply into an AC power receptacle providing power in the range 100 V to 240 V, 50 Hz or 60 Hz. Connect the power supply plug to the hub's 'DC Supply' jack J12. To connect to the PC, plug the USB A to B cable into the hub's 'Up Stream' connector P1. Plug the other end of the cable into one of the PC's host controller ports. The hub enumerates as a 'Generic USB Hub'. The hub is now ready for any low speed, full speed, or high speed devices to be plugged into the ports. For the 2-port hub, the board is labeled PORT1 and PORT 2. CY4605 EZ-USB® HX2LP™ REFERENCE DESIGN KIT QUICK START GUIDE CY4605 EZ-USB HX2LP Reference Board Details Power LED EZ-USB HX2LP CY7C65620 Port LEDs DC Supply Jack Switch SW1 Up Stream Connector EEPROM USB Connector For the latest information about this kit, visit http://www.cypress.com/go/CY4605 © 2011-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.#: 001-72640 Rev. *A