1733 Reader's Spreads pg1-203:document 1/27/09 4:03 PM Page 8 RK73Z resistors zero ohm jumper chip resistor EU features • Silver element • Anti-leaching nickel barrier terminations • Meets or exceeds EIA 575, EIAJ RC 2690A, EIA PDP-100, MIL-R-55342F • Marking: White “000” on black protective coat 1F black with no marking 1H and 1E sizes are green with no marking 1J has white “0” marking • Products with lead-free terminations meet EU RoHS requirements. Pb located in glass material, electrode and resistor element is exempt per Annex 1, exemption 5 of EU directive 2005/95/EC dimensions and construction Type c NEW c 1H (0201) .024±.001 .012±.001 .004±.002 .006±.002 .009±.001 (0.6±0.03) (0.3±0.03) (0.1±0.05) (0.15±0.05) (0.23±0.03) 1E (0402) .039 1J (0603) .063±.008 .031±.004 .012±.004 .012±.004 .018±.004 (0.3±0.1) (0.45±0.1) (1.6±0.2) (0.8±0.1) (0.3±0.1) 2A (0805) .079±.008 .049±.004 .016±.008 (2.0±0.2) (1.25±0.1) (0.4±0.2) 2B (1206) .063±.008 .126±.008 (1.6±0.2) (3.2±0.2) .102±.008 (2.6±0.2) Ni Plating Protective Coating Resistive Inner Film Electrode Ceramic Substrate 2E (1210) 2H (2010) W2H (2010) 3A (2512) W3A (2512) ordering information New Part # RK73Z 2B Type Size 1F 1H 1E 1J 2A 2B 2E 2H 3A W2H W3A T Termination Material T: Sn (1F, 1H, 1E, 1J, 2A, 2B,2E, 2H, 3A) L: SnPb (1E, 1J, 2A, 2B, 2E, 2H, 3A) G: Au (1E, 1J, 2A Contact factory) (1.0 +.004 -.002 +0.1 ) -0.05 +.002 .02±.002 .008±.004 .01 -.004 .014±.002 (0.5±0.05) (0.2±0.1) (0.25 +0.05) (0.35±0.05) -0.1 .197±.008 .098±.008 (5.0±0.2) (2.5±0.2) .012 (0.3 .016 (0.4 .02±.012 (0.5±0.3) .02±.004 (0.5±0.1) +.008 -.004 +0.2 ) -0.1 .026±.006 .024±.004 (0.65±0.15) (0.6±0.1) .016 (0.4 .248±.008 .122±.008 (6.3±0.2) (3.1±0.2) +.008 -.004 +0.2 ) -0.1 +.008 -.004 +0.2 ) -0.1 .026±.006 (0.65±0.15) TD Packaging TBL: 01005 only: 2mm pitch pressed paper TA: 0201 only: 1mm pitch pressed paper TC: 0201 only: 7" 2mm pitch pressed paper (TC: 10,000 pcs/reel, TCM: 15,000 pcs/reel) TCD: 0201 only: 10" 2mm pitch punched paper TPL: 0402 only: 2mm pitch punch paper TP: 0402, 0603, 0805: 7" 2mm pitch punch paper TD: 0603, 0805, 1206, 1210:7" 2mm pitch punched paper TDD: 0603, 0805, 1206, 1210: 10" paper tape TE: 0805, 1206, 1210, 2010 & 2512: 7" punched plastic TED: 0805, 1206, 1210, 2010 & 2512: 10" punched plastic For further information on packaging, please refer to Appendix A Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. 10 t .016±.0008 .079±.0008 .004±.001 .004±.001 .005±.0008 (0.4±0.02) (0.2±0.02) (0.10±0.03) (0.11±0.03) (0.13±0.02) Solder Plating t Dimensions inches (mm) W c d 1F (01005) W d L (Inch Size Code) L 12/14/08 KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: 814-362-8883 • www.koaspeer.com 1733 Reader's Spreads pg1-203:document 1/27/09 4:03 PM Page 9 PMS 300 neg. Black neg. zero ohm jumper chip resistor NEW applications and ratings Part Designation Maximum Continuous Current @ 70°C Maximum Surge Current @ 70°C RK73Z1F 0.5 Amps 1.0 Amp Max. for < 1 second RK73Z1H 0.5 Amps 1.0 Amp Max. for < 1 second RK73Z1E RK73Z1J 1.0 Amps 2 Amp Max. for < 1 second RK73Z2A 2.0 Amps 5 Amp Max. for < 1 second RK73Z2B RK73Z2E RK73ZW2H RK73ZW3A 2.0 Amps 10 Amp Max. for < 1 second Maximum Resistance Operating Temperature Range -55°C to +125°C 50mΩ -55°C to +155°C environmental applications Derating Curve 100 % Rated Curent 80 60 1F 40 1H 1E, 1J, 2A, 2B, 2E, 2H, 3A 20 0 -60 -40 -55 -20 0 20 40 60 80 70 Ambient Temperature (°C) 100 120 140 125 155 For resistors operated at an ambient temperature of 70°C or above, a current rating shall be derated in accordance with the above derating curve. Performance Characteristics Parameter Resistance Overload (Short time) Resistance to Solder Heat Rapid Change of Temperature Moisture Resistance Endurance at 70°C High Temperature Exposure Requirement ∆ R Limit Typical 50m Ω Max. 15m Ω Max. after the test after the test 50m Ω Max. 18m Ω Max. after the test after the test 50m Ω Max. 15m Ω Max. after the test after the test 50m Ω Max. 15m Ω Max. after the test after the test 100m Ω Max. 18m Ω Max. after the test after the test 100m Ω Max. 18m Ω Max. after the test after the test 50m Ω Max. 15m Ω Max. after the test after the test Test Method 25°C Maximum surge current for 5 seconds 260°C ± 5°C, 10 seconds ± 1 second -55°C (30 minutes), +125°C (30 minutes), 100 cycles 40°C ± 2°C, 90%-95% RH, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle 70°C ± 2°C, 1000 hours, 1.5 hr ON, 0.5 hr OFF cycle +125°C, 1000 hours: 1F, 1H +155°C, 1000 hours: 1E, 1J, 2A, 2B, 2E, W2H, W3A Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. 10/27/08 KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: 814-362-8883 • www.koaspeer.com 11 resistors RK73Z