RF SAW Filter Part Number Package Application Last Modified 802-RF2140.0M-A02 3.0 x 3.0 SMD WCDMA Mar. 14, 2007 . TYPE : WCDMA, RF-Rx SAW Filter PART NUMBER : 802-RF2140.0M-A02 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 2140.0 - MHz 2130.0~ 2150.0 MHz - 2.3 3.5 dB D.C,~ 500.0 MHz 21 35 - 500.0~ 1900.0 MHz 20 30 - 1900.0~ 2050.0MHz 25 34 - 2070.0 MHz 38 42 - 2240.0~ 2300.0 MHz 25 38 - 2300.0~ 4500.0 MHz 20 28 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 2130.0~ 2150.0 MHz - 1.7 2.3 - Amplitude Ripple 2130.0~ 2150.0 MHz - 0.5 1.5 dBp-p Maximum DC Voltage - - - 7.5 V Maximum Input Power - - - 15 dBm Operating Temperature - -5 - +70 ºC dB * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 802-RF2140.0M-A02 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map