RF SAW Filter Part Number Package Application Last Modified 802-RF2315.0M-A 3.0 x 3.0 SMD WIRBO Mar. 2, 2007 . TYPE : WIRBO, RF SAW Filter PART NUMBER : 802-RF2315.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 2315.0 - MHz 2300.0~ 2330.0 MHz - 2.1 2.5 dB D.C,~ 2170.0 MHz 20 27 - 2400.0~ 3400.0 MHz 25 30 - 3400.0~ 4500.0MHz 14 17 - dB 4500.0~ 6000.0 MHz 5 7 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 2300.0~ 2330.0 MHz - 2.0 2.4 - Amplitude Ripple dBp-p 2300.0~ 2330.0 MHz - 0.5 1.0 Maximum DC Voltage - - - 0 V Maximum Input Power - - - 10 dBm Operating Temperature - -30 - +80 ºC * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF2315.0M-A