XTL1002 • Surface Mount Seam-Weld Package • Good Frequency Stability over Temperature • Excellent Reliability • Complies with Directive 2002/95/EC (RoHS) 10.00000 MHz Crystal Unit 2 > The XTL1002 is a surface mount 5.0 x 3.2 mm crystal unit for use in wireless telecommunications devices, especially where an ultra-miniature package is needed for mobility. SM5032-4 Case Electrical Characteristics Characteristic Sym Notes Minimum Typical Nominal Frequency 10.00000 Mode of Oscillation Fundamental Storage Temperature Range Operating Temperature Range Frequency Stability over Operating Temperature Range Frequency Make Tolerance Units MHz -40 +85 °C -20 +70 °C ±20 ppm (referred to the value at 25°C) FL Equivalent Series Resistance Maximum ±20 ppm @ 25 °C ±3 °C ESR 100 Nominal Drive Level 10 Shunt Capacitance CO Load Capacitance CL uW 3 12 Insulation Resistance Ω pF pF 500 MΩ min./DC 100V Lid Symbolization (Y=year, WW=week, S=shift) line 1: 1002 line 2: YWWS C r y s ta l E q u iv a le n t C ir c u it 2 C E S R 4 O CAUTION: Electrostatic Sensitive Device. Observe precautions for handling. Notes: 1. The design, manufacturing process, and specifications of this device are subject to change without notice. www.RFM.com E-mail: [email protected] ©2009-2010 by RF Monolithics, Inc. Page 1 of 3 XTL1002 - 2/3/10 SM5032-4 Case 4-Terminal Surface-Mount Seam Weld Case 5.0 x 3.2 mm Nominal Footprint 3.2 ±0.1 5.0 ±0.1 Top View Connection 1 GND 2 IN/OUT 3 GND 4 IN/OUT Side View Note: Pin #1 & #3 are connected to metal cap on top 0.8 ±0.1 Pin 0.8 ±0.1 Electrical Connections 1.2 ±0.1 1.2 ±0.1 2.4 ±0.2 pin 2 pin 3 pin 1 pin 4 1.4 ±0.2 1.2 ±0.1 1.7 ±0.1 Bottom View Package Dimensions (mm) 2.2 ±0.1 Dot Indicates Pin 1 Footprint (mm) 1002 YWWS 1002 YWWS 1002 YWWS Package Orientation in Carrier Tape www.RFM.com E-mail: [email protected] ©2009-2010 by RF Monolithics, Inc. Page 2 of 3 XTL1002 - 2/3/10 Reel Dimensions Tape Dimensions Notes: 1. Unless otherwise specified, tolerance on dimensions is ±0.1 mm 2. Material is black conductive polystyrene 3. 10 pitch cumulative tolerance is ±0.2 mm www.RFM.com E-mail: [email protected] ©2009-2010 by RF Monolithics, Inc. Page 3 of 3 XTL1002 - 2/3/10