RFM XTL1003

XTL1003
•
Surface Mount Seam-Weld Package
•
Good Frequency Stability over Temperature
•
Excellent Reliability
•
Complies with Directive 2002/95/EC (RoHS)
13.56000 MHz
Crystal Unit
2 >
The XTL1003 is a surface mount 5.0 x 3.2 mm crystal unit for use in wireless
telecommunications devices, especially where an ultra-miniature package is
needed for mobility.
SM5032-4 Case
Electrical Characteristics
Characteristic
Sym
Notes
Minimum
Typical
Nominal Frequency
13.56000
Mode of Oscillation
Fundamental
Operating Temperature Range
Maximum
-20
Frequency Stability over Operating Temperature Range
Equivalent Series Resistance
MHz
+70
°C
±20 ppm (referred to the value at 25 °C)
FL
Frequency Make Tolerance
Units
±10 ppm @ 25 °C ±3 °C
ESR
40
Nominal Drive Level
10
Shunt Capacitance
CO
Load Capacitance
CL
20
Motional Capacitance
CM
4.2 fF ±20%
2.0
Aging
Ω
uW
pF
pF
±1.0 ppm/year @25 °C
Stanard Shipping Quantity on 330 mm (13”) Reel
3000
Lid Symbolization (in addition to Lot and/or Date Codes)
units
1003 YWWS
C r y s ta l E q u iv a le n t C ir c u it
2
C
E S R
4
O
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. The design, manufacturing process, and specifications of this device are subject to change without notice.
www.RFM.com E-mail: [email protected]
©2009-2010 by RF Monolithics, Inc.
Page 1 of 3
XTL1003 - 2/3/10
SM5032-4 Case
4-Terminal Surface-Mount Seam Weld Case
5.0 x 3.2 mm Nominal Footprint
3.2 ±0.1
5.0 ±0.1
Top View
Connection
1
GND
2
IN/OUT
3
GND
4
IN/OUT
Side View
Note: Pin #1 & #3 are connected to metal cap on top
0.8 ±0.1
Pin
0.8 ±0.1
Electrical Connections
1.2 ±0.1
1.2 ±0.1
2.4 ±0.2
pin 2
pin 3
pin 1
pin 4
1.4 ±0.2
1.2 ±0.1
1.7 ±0.1
Bottom View
Package Dimensions (mm)
2.2 ±0.1
Dot Indicates Pin 1
Footprint (mm)
1003
YWWS
1003
YWWS
1003
YWWS
Package Orientation in Carrier Tape
www.RFM.com E-mail: [email protected]
©2009-2010 by RF Monolithics, Inc.
Page 2 of 3
XTL1003 - 2/3/10
Reel Dimensions
Tape Dimensions
Notes:
1. Unless otherwise specified, tolerance on dimensions is ±0.1 mm
2. Material is black conductive polystyrene
3. 10 pitch cumulative tolerance is ±0.2 mm
www.RFM.com E-mail: [email protected]
©2009-2010 by RF Monolithics, Inc.
Page 3 of 3
XTL1003 - 2/3/10