ETC DIH-128

DIONICS, INC.
Phone: (516) 997-7474
Fax: (516) 997-7479
Website: www.dionics-usa.com
65 Rushmore Street
Westbury, NY 11590
DIH-128 Power MOSFET SPST Photovoltaic AC-DC N/O Relay
Features:
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Applications:
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Ø
Low Level Logic Compatibility
Optical Isolation to 400VDC
Low On Resistance, Low Offset Voltage
Low Off-State Leakage Current.
High Speed Switching Response.
High Transient Immunity, No False Turn on
Hermetically Sealed 6-Pin Mini DIP Foot Print
Designed To Meet MIL-R-28750
Y-Level MIL-Screening Available (DIH-128Y)
Replacement of Mechanical Relays
Motor Control & Power Control
Aircraft Flight Control Systems
A.T.E. (Automatic Test Equipment)
Load Control From Processor I/O Ports
High-side DC Power Switching
Power Supply Circuits
Medical Electronics
Description:
The DIH-128 is a State-of-the-Art Photovoltaic Solid State Relay designed for A.T.E. applications where speed, onresistance and leakage current are critical. These photovoltaic relays incorporate an infrared LED input, a photovoltaic
(PV) diode array including a unique turn-off circuit connected to the gates of a pair of high voltage MOSFETs as output.
The photovoltaic diode array is a series-connected group of photosensitive diodes, which are electrically isolated from,
but optically coupled to, the input LED. Input/Output isolation is rated at 400 VDC.
When activated, the LED emits infrared light toward the photovoltaic diode array, which then responds with a selfgenerated open circuit voltage, Voc, proportional to the LED input current. This Voc , which is floating and completely
isolated from any power supply, is applied to the Gates of the MOSFETs. At the proper value of the input LED current,
the generated Voc is sufficient to turn on the MOSFETs and cause the relay to conduct. The MOSFET outputs provide
thermal stability, immunity from false turn-on, and low offset voltage.
* DIH-128 Schematic
* Package Lay out:
0.420
6
6
PV
LED
5
4
Enh.
2
DIONICS
0.300
5
0.420
1
KOVAR, AU - PLATED
DIH-128
KOVAR, NI - PLATED
Enh.
XXXX
GLASS
4
1
3
0.150
0.020
0.175
v Pin Designation
Pin number
Function
1
Input +
2
Input 3
Case
4
Output Drain
5
Output Common Source
6
Output Drain
2
0.020
0.100
0.018 Typ.
12/2001
DIH-128: Power MOSFET SPST Photovoltaic AC-DC Relay
Electrical Characteristics (@ 25 0 C unless otherwise specified):
Wiring Configuration:
AC-DC Wiring Config. (1)
1
DC Wiring Config. (2)
Single MOSFET
2
1
DC Wiring Config. (3)
Parallel MOSFETs
1
2
2
LED
LED
LED
PV
PV
PV
Enh.
Enh
.
Enh.
Rload
Enh.
Enh.
Enh.
Rload
AC
R load
VCC
v Input Characteristics
Turn-On Current
Turn-Off Current
Forward Voltage Drop
Reverse Voltage
Condition
100 mA load
Input Current = 10mA
Input Current = 25mA
Reverse Current = 10µA
AC-DC Wiring Config. (1)
v Output Characteristics
Load Current (Continuous in Free Air)
600
On Resistance (Iin = 15mA, Vop = 30V)
1.0
Typical Output Capacitance
80
(Bias Voltage= 50V)
Off-State Leakage @ 250V
10
Output Offset Voltage (Iin = 15mA)
250
Turn-On Time*
500
Turn-Off Time*
70
Load Voltage (Il = 10mA)
250
* I led = 25 mA; f = 100 Hz; Pulse Width = 100 µs; I load = 600 mA
Storage Temp. :
(Y-Level Mil.)
Shock: (Y-Level Mil.)
Min.
−
1.2
−
−
10
Typ.
5
−
2.2
2.6
−
Max
10
−
2.7
2.9
−
Units
mA
V
V
V
V
DC Wiring Config. (2)
600
0.5
160
DC Wiring Config. (3)
1200
0.25
320
Unit
mA
Ohm
pF
10
250
500
70
250
20
250
500
70
250
µA
µV
µs
µs
V
25 mA
v Environmental Conditions:
Operating Temp. :
(Y-Level Mil.)
VCC
90%
Input
-20 to 85 0C (Comm.)
-55 to 125 0C
0
-20 to 85 C (Comm.)
-55 to 125 0C
50 G, MIL-STD-202
Method 202
Hermeticity:
Gross Leak (Comm.)
10-5 atm cc/sec
(Y-Level Mil.)
Fine Leak
5x10 -8 atm cc/sec
Vibration: (Y-Level Mil.)
20G, 10 to 2000 Hz
Acceleration: (Y-Level Mil.) 100 G
Weight:
1.5 Grams
10%
T(on)
0 mA
Td(on)
T(off)
600 mA
Td(off)
90%
90%
Output
0 mA
10%
v General Characteristics:
Minimum Input/Output Isolation:
Minimum Input/Output Resistance:
Typical Input/Output capacitance:
Typical Thermal Resistance:
Min. Transient Protection Capability (dv /dt ):
Maximum Power Dissipation @ 25 0C:
10%
400 VDC
10 8 Ohms
10pF
15mW/0C
100V/µs
1W