VECTRON FDVGLJ

Product Data Sheet
F-Type
Voltage Controlled Crystal Oscillator (VCXO)
Features
n Industry Common Pinout
n Commercial or Industrial Temperature Range
n TTL or CMOS Drive Capability
n Hermetic Package
n 5.0 V or 3.3 V Supply
Description
The F-Type Voltage Controlled Crystal Oscillator
(VCXO) is used in a phase lock loop applications
including clock recovery and frequency translation
applications. The metal package is grounded for
improved EMI performance.
The FTV Voltage Controlled Crystal Oscillator
Pin Information
Table 1. Pin Function
Pin
Symbol
1
VC
7
GND
8
Output
14
VDD
Function
VCXO Control Voltage
Case Ground
VCXO Output
Power Supply Voltage (3.3 or 5.0 V ±10%)
14
8
1
7
Performance Characteristics
Table 2. Electrical Performance
Parameter
Operating Temperature Range
1
Center Frequency
Absolute Pull Range
2
Supply Voltage
Supply Current
3
Output Voltage Levels
Output High
Output Low
3
Transition times
Rise Time
Fall Time
Fanout
Start-Up Time
Control Voltage
Fanout
Symbol
To
f0
Minimum
Typical
Maximum
0 to 70, -20 To 70, or -40 to 85
1
52
+/- 20 to +/-100
3.3 or 5.0 (+/-10%)
0.45 mA/MHz
35
VDD
IDD
VOH
VOL
0.9 VDD
TR
TF
0.1 VDD
-
tsu
VC
Fo
Units
°C
MHz
ppm
V
mA
-
2
-
0.1 VDD
V
V
5.0
5.0
10
0.9 VDD
10 TTL
ns
ns
TTL
ms
V
Loads
1. Other frequencies may be available, please contact factory with your special requirements.
2. A 0.1 µF low frequency tantalum bypass capacitor in parallel with a 0.01 µF high frequency ceramic capacitor is recommended. Both should be located as close to the FTU-Type bias pin as is practical
3. Figure 1 defines these parameters. Figure 2 illustrates the equivalent TTL load and operating conditions under which these parameters are specified and tested.
TF
TR
I DD
VOH
VS
V OL
650Ω
14
V DD
+
-
1
IC
On Time
VC
0V
+
-
7
8
15pF
1.83kΩ
Period
Figure 2. Output Test Conditions (25±
±5°C)
Figure 1. Output Waveform
Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1• http://www.vectron.com
1
F-Type VCXO
Table 3. ESD Threshold Voltage
Model
Threshold
Human-Body (HBM)
1000*
Charged-Device (CDM)
500
Handling Precautions
Although protection circuitry has been designed into this
device, proper precautions should be taken to avoid exposure
to electrostatic discharge (ESD) during handling and mounting.
VTI employs a human-body model (HBM) and a chargeddevice model (CDM) for ESD-susceptibility testing and
protection design evaluation.
Unit
Volts Min.
Volts Min.
*Mil-STD-883D, Method 3015, Class 1
Table 4. Mechanical and Environmental Compliance
Parameter
Conditions
Mechanical Shock
Mechanical Vibration
Temperature Cycle
Gross Leak
Fine Leak
Seal Strength
Bend Test
Marking
Storage Temperature
ESD voltage thresholds are dependent on the circuit
parameters used to define the mode. Although no industrywide standard has been adopted for the CDM, a standard HBM
(resistance = 1500Ω, capacitance = 100pF) is widely used and
therefore can be used for comparison purposes. The HBM
ESD threshold presented here was obtained by using these
circuit parameters.
MIL-STD-883C, 2002.3, A
MIL-STD-883C, 2007.1, A
MIL-STD-883C, 1010, A
100% Deionized Water
MIL-STD-883C, 1014.7
2 lbs Perpendicular to Top and Bottom
MIL-STD-202E, 211A, C
MIL-STD-202E, 215
-55°C to 125°C
Outline Diagram
VTI
FTVGCA
35.3280
743
Figure 3 Outline Diagram
Ordering Information
Table 5. Part Numbering
Example Part #
F
F
T
Package
Supply
Voltage (V)
T 5.0±10%
4 pin DIP
V
V
VCXO
Type
VCXO
D 3.3±10%
G
C
Pull (ppm)
F
±32
Operating
Temp. (°C)
0 to 70
C
G
±50
L
-40 to 85
H
±100
I
-20 to 70
A
±100
TPR
A
Output
Load
TTL
A
50 ±5%
B
TTL
50 ±10%
J
CMOS
K
CMOS
50 ±5%
50 ±10%
Other specifications may be available on request.
For Additional Information Please Contact:
USA: Vectron International • 267 Lowell Road, Hudson, NH 03051 • Tel: 1-88-VECTRON-1 • Fax: 1-888-FAX-VECTRON
EUROPE:
Tel: 49 (0) 3328 4784 17 • Fax: 49 (0) 3328 4784 30
ASIA:
Tel: +86 21 28909740 / 41 / 42 • Fax: +86 21 28909240 / 2890999
I
rev 1.2, 4/27/98, 08/16/02
Vectron International reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as a result of their use or
application. No rights under any patent accompany the sale of any such product(s) or information.
2