Multipurpose Boxes IP65, Polycarbonate Material Features: • • • • • • • The LID and base incorporate a tongue and groove sealing system with a neoprene gasket Wall mounting holes and LID fixing screws are outside the sealing area thus preventing the ingress of moisture and dust Designed to IP 65 of IEC 529 and nema 4 (dust and hoseproof) Internal guide slots for mounting PCB assemblies vertically Bosses on internal base allow fixing of PCB's horizontally or connection of terminals, etc into threaded brass inserts LID fixing screw are M-4 stainless steel (nonmagnetic) into threaded brass inserts High impact ABS material moulded in dark grey colour. They are easily drilled or punched. Making them Ideal for use in the electrical and electronics industries as circuit enclosures and junctions boxes Specification Table Height Width Depth 50 52 35 80 120 160 82 160 Wall Thickness Moulded In Operating Temperature Part Number G250 G256 55 G258 200 75 120 90 G279 60 G287 90 G288 160 3 Light grey (IP65, polycarbonate material) -40°C to +125°C G269 Dimensions : Millimetres Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. © Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com Page <1> 07/05/12 V1.1