DTD114GK Transistors Digital transistor (built-in resistor) DTD114GK zFeatures 1) The built-in bias resistors consist of thin-film resistors with complete isolation to allow negative biasing of the input, and parasitic effects are almost completely eliminated. 2) Only the on / off conditions need to be set for operation, making device design easy. 3) Higher mounting densities can be achieved. zCircuit schematic C B R E E : Emitter C : Collector B : Base zAbsolute maximum ratings (Ta=25°C) Parameter Collector-base voltage Symbol Limits Unit VCBO VCEO 50 50 V V VEBO IC 5 500 V mA Collector power dissipation Pc 200 mW Junction temperature Storage temperature Tj 150 Tstg −55 to +150 C C Collector-emitter voltage Emitter-base voltage Collector current zPackage, marking, and packaging specifications Part No. Package Marking Packaging code Basic ordering unit (pieces) DTD114GK SMT3 L24 T146 3000 Rev.A 1/2 DTD114GK Transistors zElectrical characteristics (Ta=25°C) Symbol Min. Typ. Max. Unit Collector-base breakdown voltage Collector-emitter breakdown voltage Parameter BVCBO BVCEO 50 50 − − − − V V IC=50µA IC=1mA Emitter-base breakdown voltage BVEBO 5 − − − − 0.5 V µA IE=720µA VCB=50V 300 − − − 580 0.3 µA V VEB=4V IC/IB=50mA/2.5mA 56 7 fT − − 10 200 − 13 − − kΩ MHz IC=50mA , VCE=5V R Collector cutoff current ICBO Emitter cutoff current Collector-emitter saturation voltage DC current transfer ratio Emitter-base resistance Transition frequency ∗ Transition frequency of the device. IEBO VCE(sat) hFE Conditions − VCE=10V , IE= −50mA , f=100MHz ∗ 1000 Ta=25°C Ta=100°C 500 VCE=5V DC CURRENT GAIN : hFE Ta=25°C 200 100 50 Ta= −40°C 20 10 5 2 1 500µ 1m 2m 5m 10m 20m 50m 100m 200m COLLECTOR CURRENT : IC (C) Fig.1 DC current transfer ratio vs. Collector current 500m COLLECTOR SATURATION VOLTAGE : VCE(sat)(V) zElectrical characteristics curves 1 Ta=25°C 500m IC/IB=20 Ta=100°C 200m 100m Ta=25°C 50m 20m Ta= −40°C 10m 5m 2m 1m 500µ 1m 2m 5m 10m 20m 50m 100m 200m 500m COLLECTOR CURRENT : IC (A) Fig.2 Collector-Emitter saturation voltage vs. Collector current Rev.A 2/2 Appendix Notes No technical content pages of this document may be reproduced in any form or transmitted by any means without prior permission of ROHM CO.,LTD. The contents described herein are subject to change without notice. The specifications for the product described in this document are for reference only. Upon actual use, therefore, please request that specifications to be separately delivered. Application circuit diagrams and circuit constants contained herein are shown as examples of standard use and operation. Please pay careful attention to the peripheral conditions when designing circuits and deciding upon circuit constants in the set. Any data, including, but not limited to application circuit diagrams information, described herein are intended only as illustrations of such devices and not as the specifications for such devices. ROHM CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any third party's intellectual property rights or other proprietary rights, and further, assumes no liability of whatsoever nature in the event of any such infringement, or arising from or connected with or related to the use of such devices. Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or otherwise dispose of the same, no express or implied right or license to practice or commercially exploit any intellectual property rights or other proprietary rights owned or controlled by ROHM CO., LTD. is granted to any such buyer. Products listed in this document are no antiradiation design. The products listed in this document are designed to be used with ordinary electronic equipment or devices (such as audio visual equipment, office-automation equipment, communications devices, electrical appliances and electronic toys). Should you intend to use these products with equipment or devices which require an extremely high level of reliability and the malfunction of with would directly endanger human life (such as medical instruments, transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other safety devices), please be sure to consult with our sales representative in advance. About Export Control Order in Japan Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control Order in Japan. In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause) on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction. Appendix1-Rev1.1