!" FEATURES • • • • • • Industry Standard 12.7x12.7mm SMT Footprint +4.75Vdc Supply Voltage -20°C to +85°C Temp. Range Low Phase Noise Tape & Reel Packaging Fully compliant to RoHS Directive 2002/95/EC VCO3060 150 M • CTS 07XX DESCRIPTION The CTS VCO3060 is a single band high performance SMT VCO. It’s low phase noise makes it the ideal choice for any wireless telecommunications system. • See WWW.CTSCORP.COM for product patent status. ELECTRICAL SPECIFICATIONS Parameter Conditions & Remarks Operating Frequency F OUT Supply Voltage VCC Supply Current I cc Operating Temperature Range TOP Storage Temperature Range TSTG Tuning Voltage Range VT Tuning Sensitivity Power Output Pushing Pulling (12dB return loss all phases) Output Impedance Input Impedance Harmonics Spurious Response 10kHz Phase Noise 100kHz 1MHz ! "# $ *** Min 150 4.5 -20 -30 0.5 13 0 -1 -1 - % ! Typical 4.75 17 3 50 100 -102 -142 & "# ' Max 200 5 13 +85 +85 4.5 21 6 1 1 -15 -80 -99 -120 -139 ( ) Unit MHz Vdc mA °C °C Vdc MHz/V dBm MHz/V MHz p-p Ohms MOhms dBc dBc dBc/Hz dBc/Hz dBc/Hz !" Pin 3 12.7±0.1 [.500±.004] 0.00 [.000] Pin 3 0.00 [.000] 2.03 [.080] VCO3060 150 M CTS 07XX Pin 1 2.92 [.115] 10.54 [.415] 4.0 MAX [.158] 5.46 [.215] 12.7±0.1 [.500±.004] 8.00 [.315] MECHANICAL SPECIFICATIONS: 2.92 [.115] 4.57 [.180] 5.46 Pin 1 [.215] 7.11 [.280] Pin 2 Pin 2 8.00 [.315] 9.78 [.385] 10.54 [.415] Ø.51 [.020] 16 places Recommended Land Pattern Pad Detail 3 Places 14.48 [.570] 1.78 TYP [.070] 2.67 [.105] 5.21 [.205] 10.29 [.405] Pin #1 mark 7.75 [.305] 12.70 [.500] 10.92 [.430] Function table Pin 1 2 3 4 1.78 [.070] TYP 1.52 [.060] TYP 10.92 [.430] 1.78 [.070] 0.79 [.031] Function Vt RF Output Vcc GND 1.32 [.052] 2.90 [.114] Note: The Lid/Sheild is grounded. 14.48 [.570] Pin 4 Exposed conductive ground plane 0.94 [.037] THIRD ANGLE PROJECTION 1.14 TYP [.045] Package outline 13 Ground Vias located approximately as shown All dimensions are in MM [Inches]. All dimensions are nominal unless otherwise specified. Lead Termination Finish: Gold Flash, <10 micro inch, over Ni plated Cu. + ! "# $ *** % ! & "# ' ( ) !" Tape & Reel Information: Tape width 24 mm, pitch 16 mm, as per EIA 481-2, 1000 units max per 330 mm reel. 4.00 [.157] 1.75 [.069] 24.00 [.945] 16.00 [.630] Ø1.5 [.059] • All dimensions are in MM [INCHES]. All dimensions are Nominal STANDARD ENVIRONMENTAL LIMITS: This product is capable of operating within the following environmental conditions: Operating Temperature:-20 to +85 °C. Storage Temperature: -30 to +85 °C. Humidity: 85% Relative humidity max @ 50°C. Solder Reflow Conditions: Device is capable of withstanding reflow of 260 degrees C for 10 seconds maximum. Atmospheric Pressure: 730 to 780 mm Hg. Moisture Sensitivity: MSL 1 RoHS: This device is fully compliant to RoHS Directive 2002/95/EC ! "# $ *** % ! & "# ' ( )