DC/DC Converters TSV Series, 1 Watt RoHS Features ◆ SMD Package (SOIC-22) ◆ Isolated Single and Dual Output Models ◆ I/O-Isolation 3‘000 VDC ◆ High Efficiency up to 81% ◆ Extended Temperature Range compliant –40°C to +85°C ◆ ◆ ◆ ◆ High Accuracy of Pin Co-Planarity Available in Tape and Reel Package Lead free Design, RoHS compliant 3 Year Product Warranty The TSV series are miniature, 1W DC/DC-converters with high isolation in a SMD package. The devices can be soldered without any problems in a high temperature lead free solder process. With the small footprint, these converters are the ideal solution for board level power distribution, mainly for applications in the industrialand telecom field. Models Ordercode Input voltage Output voltage Output current max. Efficiency typ. TSV 0505S 5 VDC 200 mA 71 % TSV 0512S 12 VDC 80 mA 78 % TSV 0515S 15 VDC 65 mA 78 % ± 5 VDC ±100 mA 72 % TSV 0512D ±12 VDC ± 40 mA 78 % TSV 0515D ±15 VDC ± 30 mA 79 % TSV 1205S 5 VDC 200 mA 71 % TSV 1212S 12 VDC 80 mA 79 % 15 VDC 65 mA 80 % ± 5 VDC ±100 mA 74 % TSV 1212D ±12 VDC ± 40 mA 80 % TSV 1215D ±15 VDC ± 30 mA 81 % TSV 2405S 5 VDC 200 mA 71 % TSV 2412S 12 VDC 80 mA 78 % 15 VDC 65 mA 79 % TSV 0505D TSV 1215S TSV 1205D TSV 2415S TSV 2405D 5 VDC ±10% 12 VDC ±10% 24 VDC ±10% ± 5 VDC ±100 mA 72 % TSV 2412D ±12 VDC ± 40 mA 79 % TSV 2415D ±15 VDC ± 30 mA 80 % http://www.tracopower.com Page 1 of 3 DC/DC Converters TSV Series 1 Watt Input Specifications Input current no load /full load 5 Vin models: 30 mA / 260 mA typ. 12 Vin models: 12 mA / 110 mA typ. 24 Vin models: 7 mA / 55 mA typ. Surge voltage (1 sec. max.) 5 Vin models: 9 V max. 12 Vin models: 18 V max. 24 Vin models: 30 V max. Reverse voltage protection 0.3 A max. Reflected input ripple current* can be reduced by ext. 1–3.3 µF polyester film capacitor Input filter internal capacitor Output Specifications Voltage set accuracy ±3% Voltage balance (dual output models, balanced load) ± 1 % max. Regulation ± 1.2 % / 1 % change Vin ± 10 % max. – Input variation – Load variation 20 – 100 % Ripple and noise (20 MHz Bandwidth) 75 mV pk-pk max. Temperature coefficient ± 0.02 % / K Short circuit protection limited 0.5 sec. max. Capacitive load 5 VDC single 5 VDC dual 12/15 VDC single 12/15 VDC dual output output output output models: models: models: models: 33 µF max. 10 µF max. 4.7 µF max. 2.2 µF max. General Specifications Temperature ranges – Operating – Case temperature – Storage –40 °C ... +85 °C (no derating) +95 °C max. –40 °C ... +105 °C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217F) >2’000’000 h @ 25 °C Isolation voltage (Input/Output) 3‘000 VDC Isolation capacity (Input/Output) 60 pF typ. Isolation resistance (Input/Output) >10‘000 M Ohm (500VDC) Switching frequency 100 kHz typ. (frequency modulation) Frequency change over line and load ± 30 % max. Physical Specifications Case material non conductive FR4 (UL 94V-0 rated) Package weight 2.2 g (0.07 oz) Reflow soldering profile peak temp. 245°C (10 sec max.) 217°C for 90 sec. max. Convection reflow solder process is recommended All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 3 DC/DC Converters TSV Series 1 Watt Derating all Models +85˚C +105˚C Output Power [%] 90 90 80 80 70 70 60 60 50 50 -5.0% /˚C 40 40 30 30 20 20 10 10 0 Output Power [%] 100 100 0 -40 -30 -20 -10 0 10 20 30 40 50 60 Ambient Temperature [˚C] 70 80 90 100 110 Outline Dimensions 6.5 (0.256) (0.1) (0.1) 5.08 2.54 (0.2) (0.1) 0.25 (0.01) Plane 10 Pins ± 4˚ 7.0 (0.27) 0.2 M S P 9.2 (0.36) 0.6 11.2 (0.44) (0.024) 22 (0.26) 6.7 2.54 2.54 0.25 1.3 (0.05) (0.01) (0.18) 4.7 S Seating 20 18 14 12 8.0 (0.31) Pin-Out 1 3 5 15.24 (0.6) 9 11 1.0 Solder pad 1.8 12.7 (0.50) 2.54 2.54 (0.1) (0.1) 5.08 2.54 (0.2) (0.1) Specifications can be changed without notice (0.01) (0.04) Pin Single Dual 1 –Vin (GND) –Vin (GND) 3 +Vin (Vcc) +Vin (Vcc) 5 No con. No con. 9 –Vout Common 11 No con. –Vout 12 No con. No con. 14 +Vout +Vout 18 No con. No con. 20 No con. No con. 22 No con. No con. Dimensions in [mm], () = Inch Pin diameter: 1.0 ±0.05 (0.02 ±0.002) Pin pitch tolerances: ±0.13 (±0.005) Case tolerances: ±0.25 (±0.01) Rev. 12/05.1 Jenatschstrasse 1 · CH-8002 Zurich · Switzerland Tel. +41 43 311 45 11 · Fax +41 43 311 45 45 · [email protected] · www.tracopower.com Page 3 of 3