DC/DC Converters TES 5WI Series, 5 Watt Features ◆ Compact SMD package ◆ 33.4 x 25.6 mm footprint ◆ Ultra-wide 4:1 input voltage range ◆ I/O isolation 1500 VDC ◆ Operating temp. range –40 °C to 71 °C ◆ Short circuit protection ◆ Input filter to meet EN 55022, class A ◆ Remote On/Off ◆ High accuracy of pin co-planarity ◆ Qualified for leadfree reflow solder UL UL 60950-1 60950-1 pending process according IPC/JEDEC J-STD-020D ◆ 3-year product warranty The TES-5WI series is a family of high performance 5W dc/dc-converter modules in a low profile SMD package with compact dimensions. The 14 modules feature ultrawide 4:1 input ranges with tightly regulated output voltage. High efficiency allows an operating temperature range of –40 to +71°C without derating. Further features are built-in EMI-filter to meet EN 55022 class A without external components and remote On/Off control. The products comply with IPC J-STD-020D and are qualified for high temperature lead-free reflow solder process. Models Order code Input voltage Output voltage Output current max. Efficiency typ. TES 5-2410WI 3.3 VDC 1‘200 mA 76 % TES 5-2411WI 5 VDC 1‘000 mA 80 % TES 5-2412WI TES 5-2413WI TES 5-2421WI 9 – 36 VDC (24 VDC nominal) 12 VDC 420 mA 83 % 15 VDC 335 mA 83 % ± 5 VDC ± 500 mA 80 % TES 5-2422WI ± 12 VDC ± 210 mA 83 % TES 5-2423WI ± 15 VDC ± 165 mA 83 % TES 5-4810WI 3.3 VDC 1‘200 mA 76 % TES 5-4811WI 5 VDC 1‘000 mA 80 % 12 VDC 420 mA 83 % 15 VDC 335 mA 83 % TES 5-4812WI TES 5-4813WI TES 5-4821WI 18 – 75 VDC (48 VDC nominal) ± 5 VDC ± 500 mA 80 % TES 5-4822WI ± 12 VDC ± 210 mA 83 % TES 5-4823WI ± 15 VDC ± 165 mA 83 % http://www.tracopower.com Page 1 of 3 DC/DC Converters TES 5WI Series 5 Watt Input Specifications Input current at full load 24 V models: 250 mA typ. 48 V models: 125 mA typ. Input current at full load 24 V models: 20 mA typ. 48 V models: 10 mA typ. Start-up voltage / under voltage shut down 24 V models: 9 VDC / 8 VDC typ. 48 V models: 18 VDC / 16 VDC typ Surge voltage (1 sec. max.) 24 V models: 50 V max. 48 V models: 100 V max. Reverse voltage protection 1.0 A max. Reflected input ripple current 24 V models: 10 mA typ. 48 V models: 5 mA typ. Input filter EN 55022 class A, FCC part 15, level A Output Specifications Voltage set accuracy ±2 % Regulation – Input variation Vin min. to Vin max. 1.0 % max. – Load variation 10 – 100 % single output models: 1.0 % max. dual output models balanced load: 3.0 % max. Minimum load 10 % of rated max current (operation at lower load condition is safe but a higher output ripple will be experienced) Temperature coefficient ±0.02 % / °C max. Ripple and noise 85 mVpk-pk max. Dynamic load response 25% load change 6 % max. peak variation 500 µS max. response time Transient response (25% load step change) 200 µs typ. Current limitation >115 % of Iout max. Short circuit protection continuous, automatic recovery Capacitive load Remote On/Off 3.3 & 5 12 15 ±5 ±12 ±15 VDC VDC VDC VDC VDC VDC models: models: models: models: models: models: 2000 µF 470 µF 330 µF ±680 µF ±330 µF ±220 µF – On: 2.5 to 5.5 V or open circuit – Off: –0.7 to 0.8 V or short circuit pin 3 and pin 1/2 – Off idle current: 10 mA General Specifications Temperature ranges – Operating –40°C to +71 °C – Case temperature +100°C max. – Storage –40°C to +125 °C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217F, at 25°C, ground benign) >1‘000‘000 h Isolation voltage (60 sec.) – Input/Output 1‘500 VDC Isolation capacity – Input/Output 750 pF max. Isolation resistance – Input/Output >1‘000 Mohm Switching frequency 340 kHz typ. (frequency modulation PFM) Safety standards UL 60950-1, EN 60950-1, IEC 60950-1 Safety approvals CSA File No. 226037 http://directories.csa-international.org (entry pending) All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 3 DC/DC Converters TES 5WI Series 5 Watt Physical Specifications Case material non conductive plastic (UL 94V-0 rated) Package weight 14 g (0.49 oz) Lead-free reflow solder process as per IPC J-STD-020D Moisture sensivity level (MSL) as per IPC J-STD-033B MSL report level 2 www.tracopower.com/products/tes5wi_msl-report.pdf (publication pending) Outline Dimensions 33.4 (1.31) Pin-Out Detail A Seating Plane Pin 1 0.4 (0.016) (0.40) 10.2 S –Vin (GND) Common 22.6 (0.89) 10 No con. No con. 11 No con. –Vout 12 No con. No con. 13 No con. No con. 14 +Vout +Vout 15 No con. No con. 16 –Vout Common 22 +Vin (Vcc) +Vin (Vcc) 23 +Vin (Vcc) +Vin (Vcc) 24 No con. No con. 5 1. 6) .0 (0 15.24 2.54 (0.11) (0.6) (0.1) (0.06) 27.0 (1.06) 3 x 2.54 (0.6) (3 x 0.1) (0.006) 2.7 1.5 0.15 12 15.24 –Vin (GND) No con. 0.15 2 x 2.54 –Vin (GND) –Vin (GND) Top View (2 x 0.1) 2 9 Detail A Pin Patterns: Remote On/Off Remote On/Off 3 13 1 Dual 20.6 (0.81) 25.6 (1.01) 24 Single Dimensions in [mm], () = Inch Tolerances ±0.25 (0.02) Pin pich tolerances ±0.13 (0.005) 2.7 (0.11) 3.0 (0.12) 1.9 (0.059) Specifications can be changed any time without notice. Rev. 07/08 Jenatschstrasse 1 · CH-8002 Zurich · Switzerland Tel. +41 43 311 45 11 · Fax +41 43 311 45 45 · [email protected] · www.tracopower.com Page 3 of 3