DC/DC Converters TMV Series, 1 Watt RoHS compliant Features ◆ Single-in-Line (SIL) Package ◆ Isolated Single and Dual Output Models ◆ I/O-Isolation 3‘000 VDC ◆ High Efficiency up to 81% ◆ Extended Temperature Range –40°C to +85°C ◆ ◆ ◆ ◆ Pin-compatible with other Manufacturers 100% Burn-in (8 h) Lead free Design, RoHS compliant 3 Year Product Warranty The TMV series are miniature, isolated 1 W DC/DC-converters with high isolation in a Single-in-Line package (SIP). Requiring only 1.2 cm2 board space they offer the ideal solution in many space critical applications for board level power distribution. The use of SMD-technology makes it possible to offer a product with high performance at low cost. Models Output current max. Efficiency typ. TMV 0505S Ordercode 5 VDC 200 mA 71 % TMV 0512S 12 VDC 80 mA 78 % 15 VDC 65 mA 78 % TMV 0505D ± 5 VDC ±100 mA 72 % TMV 0512D ±12 VDC ± 40 mA 78 % TMV 0515D ±15 VDC ± 30 mA 79 % TMV 1205S 5 VDC 200 mA 73 % TMV 1212S 12 VDC 80 mA 80 % TMV 0515S TMV 1215S Input voltage 5 VDC ±10% 12 VDC ±10% Output voltage 15 VDC 65 mA 80 % TMV 1205D ± 5 VDC ±100 mA 74 % TMV 1212D ±12 VDC ± 40 mA 81 % TMV 1215D ±15 VDC ± 30 mA 81 % TMV 2405S 5 VDC 200 mA 71 % TMV 2412S 12 VDC 80 mA 78 % 15 VDC 65 mA 79 % TMV 2405D ± 5 VDC ±100 mA 72 % TMV 2412D ±12 VDC ± 40 mA 79 % TMV 2415D ±15 VDC ± 30 mA 80 % TMV 2415S http://www.tracopower.com 24 VDC ±10% Page 1 of 3 DC/DC Converters TMV Series 1 Watt Input Specifications Input current no load /full load 5 Vin models 30 mA / 260 mA typ. 12 Vin models 12 mA / 110 mA typ. 24 Vin models 7 mA / 50 mA typ. Surge voltage (1 sec. max.) 5 Vin models 9 V max. 12 Vin models 18 V max. 24 Vin models 30 V max. Reverse voltage protection 0.3 A max. Reflected input ripple current* can be reduced by ext. 1–3.3 µF polyester film capacitor Input filter internal capacitor Output Specifications Voltage set accuracy ±3% Voltage balance (dual output models) ± 1 % max. Regulation ± 1.2 % / 1 % change Vin ± 10 % max. – Input variation – Load variation 20 – 100 % Ripple and noise (20 MHz Bandwidth) 100 mV pk-pk max. Temperature coefficient ± 0.02 % / K Short circuit protection limited 1 sec. max. Capacitive load single output models: 680 µF max. dual output models: 220 µF max. General Specifications Temperature ranges – Operating – Case temperature – Storage –40 °C ... +85 °C +95 °C max. –40 °C ... +105 °C Humidity (non condensing) 95 % rel H max. Reliability, calculated MTBF (MIL-HDBK-217E) >2’000’000 h @ 25 °C Isolation voltage Input/Output 3‘000 VDC Isolation capacity Input/Output 60 pF typ. Isolation resistance Input/Output >10‘000 M Ohm Switching frequency 100 kHz typ. (Frequency modulation) Frequency change over line and load ± 30 % max. All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 3 DC/DC Converters TMV Series 1 Watt Physical Specifications Case material non conductive FR4 (UL 94V-0 rated) Package weight 2.1 g (0.07 oz) 2.6 g (0.09 oz) – Single output models – Dual output models Soldering temperature max. 265°C / 10 sec Outline Dimensions mm (inches) 10.2 (0.4) 3.2 (0.13) 0.5 (0.02) Pin-Out 0.5 (0.02) 2.3 ±0.4 (0.09 ±0.02) 2.54 2.54 2.54 7.62 (0.3) (0.1) (0.1) Pin Single Dual 1 +Vin (Vcc) +Vin (Vcc) 2 –Vin (GND) –Vin (GND) 5 –Vout –Vout 6 No pin Common 7 +Vout +Vout 0.5 (0.02) (0.1) 0.5 (0.02) 24 V Models 7.1 (0.28) 7 6.1 (0.24) 6 5.75 (0.23) 5 4.75 (0.19) 2 (0.05) 1 1.25 Bottom view 0.25 (0.01) 19.5 (0.77) Tolerances ±0.25 (0.01) pins ±0.05 (0.002) Specifications can be changed without notice Rev. 10/05.1 Jenatschstrasse 1 · CH-8002 Zurich · Switzerland Tel. +41 43 311 45 11 · Fax +41 43 311 45 45 · [email protected] · www.tracopower.com Page 3 of 3