Broadband Modem Mixed-Signal Front End AD9867 FEATURES FUNCTIONAL BLOCK DIAGRAM XTAL OSCIN CLKOUT1 CLKOUT2 AD9867 2M CLK MULTIPLIER PWR_DWN CLK SYN/DIST TX PWDN DELAY DCTCXO TXEN/TXSYNC IOUT_P+ TXCLK/TXQUIET THIRD-ORDER LPF f–3dB = 33MHz 10 RXCLK RXEN/RXSYNC SPORT ATTEN/RXQUIET IOUT_P– 0 TO –7.5dB ADIO[4:0]/ Rx[4:0] RXSELECT TxDAC 2×/4× 10 ADIO[9:5]/ Tx[4:0] AGC[4:0] TX_DISABLE 2-POLE LPF 1-POLE LPF RX2– 0dB TO 6dB – 6dB TO +18dB –6dB TO +24dB Δ = 1dB Δ = 6dB Δ = 6dB 5 4 RX2+ ADC 80MSPS REGISTER CONTROL RX1+ 1 RX1– 1 06203-001 Low cost, 3.3 V CMOS MxFE® for broadband modems 10-bit digital-to-analog converter (DAC) 2×/4× interpolation filter 250 MSPS DAC update rate 10-bit, 75 MSPS ADC Low noise RxPGA Dual channel muxed input 6 dB input overload attenuator −12 dB to +48 dB (without attenuator) Third-order programmable low-pass filter Flexible digital datapath interface Half-duplex and full-duplex operation Programmable delay Tx driver disable signal Various power-down/reduction modes Internal clock multiplier (PLL) 2 auxiliary programmable clock outputs 64-lead LFCSP Figure 1. APPLICATIONS Power-line networking GENERAL DESCRIPTION The AD9867 is a mixed-signal front-end (MxFE) IC for transceiver applications requiring Tx and Rx path functionality with data rates up to 75 MSPS. Its flexible digital interface, power-saving modes, and high Tx-to-Rx isolation make the part well suited for half-duplex and full-duplex applications. The digital interface is extremely flexible allowing simple interfaces to digital back ends. Power-saving modes can reduce power consumption of individual functional blocks or can power down unused blocks in half-duplex applications. A serial port interface (SPI®) allows software programming of the various functional blocks. An on-chip PLL clock multiplier and synthesizer provide all the required internal clocks, as well as two external clocks from a single crystal or clock source. The receive path consists of a programmable amplifier (RxPGA), a tunable low-pass filter (LPF), and a 10-bit analogto-digital converter (ADC). The low noise RxPGA has a programmable gain range of −12 dB to +48 dB in 1 dB steps. Its input referred noise is less than 3.6 nV/√Hz for gain settings beyond 36 dB. An optional attenuator provides an additional 6 dB (or more) of attenuation (when combined with external series resistors). The receive path LPF cutoff frequency can either be set over a 22 MHz to 38 MHz range or simply bypassed. The 10-bit ADC achieves excellent dynamic performance over a 5 MSPS to 75 MSPS span. Both the RxPGA and the ADC offer scalable power consumption allowing power/performance optimization. The Tx signal path consists of a bypassable 2×/4× low-pass interpolation filter and a 10-bit, 250 MSPS TxDAC. The transmit path signal bandwidth can be as high as 33.6 MHz at an input data rate of 75 MSPS. The TxDAC provides differential current outputs that can be steered directly to a differential or single-ended external load. Tx power can be digitally controlled over a 7.5 dB range in 0.5 dB steps. The AD9867 provides a highly integrated solution for broadband modems. It is available in a space-saving, 64-lead LFCSP and is specified over the commercial (−40°C to +85°C) temperature range. For more information on the AD9867, contact Analog Devices, Inc. at email [email protected]. Rev. SpA Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties that may result from its use. Specifications subject to change without notice. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices. Trademarks and registered trademarks are the property of their respective owners. One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A. Tel: 781.329.4700 www.analog.com Fax: 781.461.3113 ©2007 Analog Devices, Inc. All rights reserved. AD9867 ©2007 Analog Devices, Inc. All rights reserved. Trademarks and registered trademarks are the property of their respective owners. D06203F-0-1/07(SpA) T T Rev. SpA | Page 2 of 2