White Electronic Designs EDI8L32128V 128Kx32 CMOS High Speed Static RAM FEATURES DESCRIPTION 128Kx32 bit CMOS Static Analog SHARC TM External Memory Solution ADSP-21060L ADSP-21062L Random Access Memory Array Fast Access Times: 12, 15 and 20ns User Configurable Organization with Minimal Additional Logic Master Output Enable and Write Control TTL Compatible Inputs and Outputs Fully Static, No Clocks Surface Mount Package 68 Lead PLCC, No. 99 (JEDEC MO-47AE) Small Footprint, 0.990 Sq. In. Multiple Ground Pins for Maximum Noise Immunity The EDI8L32128V is a high speed, 3.3V, four megabit density Static RAM. The device is available with access times of 12, 15 and 20ns, allowing the device to support 60MHZ DSPs with no wait states. The high speed, 3.3V supply voltage and byte configurability make the device ideal for interfacing with Analog Devices ADSP-21062L or ADSP-21060L SHARC DSPs. The device can be configured as a 128Kx32 and used to create a single chip external data memory solution for the SHARC (figure 1). Providing a 51% space savings when compared to four 128Kx8, 400mil wide plastic SOJs. The EDI8L32128V has a 10pf load on the data lines vs. 24pf for four plastic SOJs. Memory upgrades in the same footprint can be accomplished with the EDI8L32256V (256Kx32) or the EDI8L32512V (512KX32). This is covered in detail in the application report "The EDI's x32 MCM-L SRAM Family: Integrated Memory Solution for the Analog SHARC DSP" Alternatively the device's chip enables can configure it as a 256Kx16. A 256Kx48 program memory array for the SHARC is created using three devices (figure 2). If this memory is too deep, two 128Kx24's (EDI8L24128V) can be used to create a 128Kx48 memory array. Single 3.3V (±5%) Supply Operation Note: Solder Reflow temperature should not exceed 260°C for 10 seconds PIN CONFIGURATIONS AND BLOCK DIAGRAM PIN NAMES 9 8 7 6 5 4 3 2 1 68 67 66 65 64 63 62 61 DQ16 NC NC E3# E2# E1# E0# NC VCC NC NC G# W# A16 A15 A14 DQ15 AØ-A16 EØ#-E3# W# G# DQØ-DQ31 VCC VSS NC 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 DQ14 DQ13 DQ12 VSS DQ11 DQ10 DQ9 DQ8 VCC DQ7 DQ6 DQ5 DQ4 VSS DQ3 DQ2 DQ1 A0-A16 G# W# E0# E1# E2# E3# DQ31 A6 A5 A4 A3 A2 A1 A0 VCC A13 A12 A11 A10 A9 A8 A7 DQ0 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 DQ17 DQ18 DQ19 VSS DQ20 DQ21 DQ22 DQ23 VCC DQ24 DQ25 DQ26 DQ27 VSS DQ28 DQ29 DQ30 Address Inputs Chip Enables (One per Byte) Master Write Enable Master Output Enable Common Data Input/Output Power (+3.3V±10%) Ground No Connection 17 128Kx32 Memory Array DQ0-DQ7 DQ8-DQ15 DQ16-DQ23 DQ24-DQ31 Note: Pin 2 & 67 on the 64Kx32 (EDI8L3265C) and the 256Kx32 (EDI8L32256C) are word select pins. White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 1 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs ABSOLUTE MAXIMUM RATINGS* Voltage on any pin relative to VSS Operating Temperature TA (Ambient) Commercial Industrial Storage Temperature Power Dissipation Output Current. Junction Temperature, TJ EDI8L32128V RECOMMENDED DC OPERATING CONDITIONS -0.5V to 4.6V Parameter Supply Voltage Supply Voltage Input High Voltage Input Low Voltage 0°C to + 70°C -40°C to +85°C -55°C to +125°C 3 Watts 20 mA 175°C Sym VCC VSS VIH VIL Min 3. 135V 0 2.2 -0.3 Typ 3.3 0 — — Max 3.465V 0 VCC+0.3 0.8 Units V V V V AC TEST CONDITIONS Input Pulse Levels Input Rise and Fall Times Input and Output Timing Levels Output Load *Stress greater than those listed under "Absolute Maximum Ratings" may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions greater than those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. VSS to 3.0V 5ns 1.5V Figure 1 (note: For tEHQZ,tGHQZ and tWLQZ, CL = 5pF) (see figure 2) Figure 2 Figure 1 VCC Z0 = 50 Ω Q 319 65 pF DOUT RL = 50 Ω 353 Ω 5 pF VL = 1.5V DC ELECTRICAL CHARACTERISTICS Parameter Sym Operating Power Supply Current ICC1 Standby (TTL) Supply Current ICC2 Full Standby CMOS Supply Current ICC3 Input Leakage Current Output Leakage Current Output High Volltage Output Low Voltage ILI ILO VOH VOL Conditions W# = VIL, II/O = 0mA, Min Cycle E# VIH, VIN VIL or VIN VIH, f=ØMHZ E# VCC-0.2V VIN VCC-0.2V or VIN 0.2V VIN = 0V to VCC V I/O = 0V to VCC IOH = -4.0mA IOL = 8.0mA Min Max 12 15 20 Units ns 680 660 620 mA 120 120 120 mA 40 40 40 mA ±10 ±10 µA µA V V 2.4 0.4 Typical:TA=25°C, VCC=3.3V TRUTH TABLE G# X H L X E# H L L L W# X H H L Mode Standby Output Deselect Read Write Output High Z High Z DOUT DIN CAPACITANCE (f=1.0MHZ, VIN=VCC or VSS) Power ICC2, ICC3 ICC1 ICC1 ICC1 Parameter Address Lines Data Lines Write & Output Enable Lines Chip Enable Lines Sym CA CD/Q W#, G# EØ# - E3# Max 40 10 40 8 Unit pF pF pF pF These parameters are sampled, not 100% tested. White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 2 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs EDI8L32128V AC CHARACTERISTICS READ CYCLE Symbol Parameter JEDEC tAVAV tAVQV tELQV tELQX tEHQZ tAVQX tGLQV tGLQX tGHQZ Read Cycle Time Address Access Time Chip Enable Access Time Chip Enable to Output in Low Z (1) Chip Disable to Output in High Z (1) Output Hold from Address Change Output Enable to Output Valid Output Enable to Output in Low Z (1) Output Disable to Output in High Z(1) 12ns Alt. tRC tAA tACS tCLZ tCHZ tOH tOE tOLZ tOHZ Min 12 15ns Max Min 15 12 8 20ns Max Min 20 Max 15 10 2 3 7 20 20 3 8 3 3 5 10 3 6 2 2 4 8 2 5 8 Units ns ns ns ns ns ns ns ns ns Note 1: Parameter guaranteed, but not tested. READ CYCLE 1 - W# HIGH, G#, E# LOW tAVAV ADDRESS 1 A ADDRESS 2 tAVQX tAVQV Q DATA 1 DATA 2 READ CYCLE 2 - W# HIGH tAVAV A tAVQV BSx#, E# tELQV tEHQZ tGLQV tGLQX tGHQZ tELQX G# Q White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 3 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs EDI8L32128V AC CHARACTERISTICS WRITE CYCLE Symbol Parameter JEDEC tAVAV tELWH tELEH tAVWL tAVEL tAVWH tAVEH tWLWH tWLEH tWHAX tEHAX tWHDX tEHDX tWLQZ tDVWH tDVEH tWHQX Write Cycle Time Chip Enable to End of Write Address Setup Time Address Valid to End of Write Write Pulse Width Write Recovery Time Data Hold Time Write to Output in High Z (1) Data to Write Time Output Active from End of Write (1) Alt. tWC tCW tCW tAS tAS tAW tAW tWP tWP tWR tWR tDH tDH tWHZ tDW tDW tWLZ 12ns Min 12 8 8 0 0 9 9 9 9 0 0 0 0 0 5 5 2 15ns Max Min 15 9 9 0 0 10 10 10 10 0 0 0 0 0 6 6 2 5 20ns Max 6 Min 20 15 15 0 0 15 15 15 15 0 0 0 0 0 8 8 2 Max 7 Units ns ns ns ns ns ns ns ns ns ns ns ns ns ns ns ns ns Note 1: Parameter guaranteed, but not tested. WRITE CYCLE 1 - W# CONTROLLED tAVAV A BSx#, E# tELWH tAVWH tWHAX tWLWH W# tAVWL tDVWH tWHDX DATA VALID D tWLQZ tWHQX Q White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 4 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs EDI8L32128V WRITE CYCLE 2 - E# CONTROLLED tAVAV A tELEH tAVEL BSx#, E# tAVEH tEHAX tWLEH W# tEHDX tDVEH DATA VALID D HIGH Z Q ORDERING INFORMATION Commercial (0°C to 70°C) Part Number EDI8L32128V12AC EDI8L32128V15AC EDI8L32128V20AC Speed (ns) 12 15 20 Industrial (-40°C to +85°C) Package No. 99 99 99 Part Number Speed (ns) Package No. EDI8L32128V12AI 12 99 EDI8L32128V15AI 15 99 EDI8L32128V20AI 20 99 PACKAGE DESCRIPTION Package No. 99 68 Lead PLCC JEDEC MO-47AE 0.995 Max 0.956 Max THETA JA=40°C/W THETA JC=15°C/W WEIGHT =4.2G 0.995 0.956 Max Max 0.180 Max 0.040 Max 0.020 0.015 0.050 BSC 0.930 0.890 0.115 Max White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 5 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs EDI8L32128V Figure 1 EDI8L32128V Address Bus A31 - A0 A16 A15 A14 A13 A12 Analog ADSP - 2106XL MS0# E0# E1# E2# E3# WR# W# RD# G# D47 - D0 D A T A B U S B U S A4 A3 A2 A1 A0 Databus A D D R E S S DQ31 DQ30 DQ29 DQ28 DQ27 DQ4 DQ3 DQ2 DQ1 DQ0 D47 D46 .. D31 D30 .. D5 D4 D3 D2 D1 D0 Figure 2 EDI8L32128V (Configured as 256Kx16) D A T A B U S A16-A0 E0# E1# E2# E3# W# G# Address Bus A31 - A0 MS0# MS1# DQ31 DQ15 DQ16 DQ15 WORD1 DQ0 DQ0 WR# EDI8L32128V RD# (Configured as 256Kx16) D A T A B U S A16-A0 E0# E1# E2# E3# W# G# Analog ADSP - 2106XL DQ31 DQ31 DQ16 DQ15 WORD2 DQ16 DQ0 EDI8L32128V (Configured as 256Kx16) D A T A B U S A16-A0 E0# E1# E2# E3# W# G# Databus D47 - D0 DQ31 DQ47 DQ16 DQ15 WORD3 DQ17 DQ0 White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 6 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com White Electronic Designs EDI8L32128V Document Title 128Kx32 CMOS High Speed Static RAM Revision History Rev # History Release Date Status Rev 6 6.1 Corrected pin configuration and block diagram on page 1 7-2004 Final 6.2 Changed pin 64 from "NC" to "A16" 6.3 Added new title page White Electronic Designs Corp. reserves the right to change products or specifications without notice. July 2004 Rev. 6 7 White Electronic Designs Corporation • (602) 437-1520 • www.wedc.com