M32170T-PTC Converter for In-circuit Connection (for 32170, 32174 Group) Function External View and Dimensions This converter is used exclusively for debugging with the emulator M32100T5-SDI-E, M32100T3-SDI-E, M32100T2-SDI-E or M32100T-SDI-E (Discontinued product) when the target is an M3217xFxxFP of M32R Family 32170 and 32174 Group MCUs and is connected in-circuit with the emulator. It allows debugging such as real-time tracing. It is not only for debugging but also for evaluation by mounting on the target system. Attaching Procedure When debugging (1) Mount NQPACK240SD on the foot pattern on the target system. (2) On top of (1), mount YQPACK240SD. (3) Screw down the YQPACK240SD with YQ-GUIDE's. (4) Connect the JTAG cable mounted on the probe of the emulator to the M32170T-PTC. (5) Connect the M32170T-PTC and YQPACK240SD. During board-mounted evaluation Package Components On NQPACK240SD mounted on the target system, first put an • M32170T-PTC converter MCU (M3217xFxxFP), and then the HQPACK240SD (option). • YQPACK240SD (made by Tokyo Eletech Co., Ltd.) • NQPACK240SD (made by Tokyo Eletech Co., Ltd.) • YQ-GUIDE (× 4) • Phillips screw driver (made by Tokyo Eletech Co., Ltd.) • User's manual *Required components to connect to the target system are included with this product package. Each component made by Tokyo Eletech Co., Ltd. is optionally available alone from Tokyo Eletech Co., Ltd. See Appendix G "Contact Addresses for Partner Products". Recommended Foot Pattern (Unit: mm) [Ordering Information] See Appendix H "Ordering Information". *All brand names and product names are trademarks or registered trademarks of their respective companies.