3.8x2.0mm DOME LENS SMD CHIP LED LAMP APED3820SRC-F01 Features z3.8mmx2.0mm zLOW Description SMT LED,3.2mm THICKNESS. POWER CONSUMPTION. zIDEAL Diode. COLORS AND LENS TYPES AVAILABLE. zPACKAGE zRoHS The Super Bright Red source color devices are made with Gallium Aluminum Arsenide Red Light Emitting FOR BACKLIGHT AND INDICATOR. zVARIOUS SUPER BRIGHT RED : 500PCS / REEL. COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.008") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAF1201 REV NO: V.1 DATE: MAR/16/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203001183 Selection Guide Part No. Dice APED3820SRC-F01 Iv (mcd) @ 20mA Lens Type SUPER BRIGHT RED (GaAlAs) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 110 240 60°(H) 35°(V) Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Super Bright Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 660 nm IF=20mA Super Bright Red 640 nm IF=20mA Spectral Line Half-width Super Bright Red 20 nm IF=20mA C Capacitance Super Bright Red 45 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Red 1.85 2.5 V IF=20mA IR Reverse Current Super Bright Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Red Units Power dissipation 100 mW DC Forward Current 30 mA Peak Forward Current [1] 155 mA 5 V Reverse Voltage -40°C To +85°C Operating / Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAF1201 REV NO: V.1 DATE: MAR/16/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203001183 Super Bright Red APED3820SRC-F01 SPEC NO: DSAF1201 REV NO: V.1 DATE: MAR/16/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203001183 APED3820SRC-F01 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF1201 REV NO: V.1 DATE: MAR/16/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: H.Q.YUAN ERP:1203001183