3.0mmx1.5mm SMD CHIP LED LAMP APL3015SEC-F01 Features z3.0mmx1.5mm zLOW Description SMT LED, 1.4mm THICKNESS. POWER CONSUMPTION. zWIDE The Super Bright Orange device is made with DH InGaAlP (on GaAs substrate) light emitting diode chip. VIEWING ANGLE. zIDEAL FOR BACKLIGHT AND INDICATOR. zVARIOUS COLORS AND LENS TYPES AVAILABLE. zPACKAGE zRoHS SUPER BRIGHT ORANGE : 2000PCS / REEL. COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.2(0.0079") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAF1074 REV NO: V.1 DATE: MAR/15/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1203001608-01 Selection Guide Part No. Dice APL3015SEC-F01 Iv (mcd) @ 20mA Lens Type SUPER BRIGHT ORANGE (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2 θ 1/2 180 500 70° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Orange λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 610 nm IF=20mA Super Bright Orange 601 nm IF=20mA Spectral Line Half-width Super Bright Orange 29 nm IF=20mA C Capacitance Super Bright Orange 30 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Orange 2.0 2.5 V IF=20mA IR Reverse Current Super Bright Orange 10 uA VR= 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Orange Units 75 mW DC Forward Current 30 mA Peak Forward Current [1] 195 mA Reverse Voltage 5 V Operating / Storage Temperature -40°C To +85°C Power dissipation Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAF1074 REV NO: V.1 DATE: MAR/15/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1203001608-01 Super Bright Orange APL3015SEC-F01 SPEC NO: DSAF1074 REV NO: V.1 DATE: MAR/15/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1203001608-01 APL3015SEC-F01 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF1074 REV NO: V.1 DATE: MAR/15/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1203001608-01