SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz Features • • • • • • • • Operates DC - 4 GHz on Single Supply ASIC TTL / CMOS Driver Leadless 4 x 7 mm Chip Scale Plastic Package Low DC Power Consumption 50 Ohm Nominal Impedance Test Boards are Available Tape and Reel are Available CSP-2 Package Rev. V8 Pin Configuration1,2,3,4 Description M/A-COM's SW90-0004A is a SP6T absorptive pHEMT switch with integral TTL driver. This device is in an MLP plastic surface mount package. This switch offers excellent broadband performance and repeatability from DC to 4 GHz, while maintaining low DC power dissipation. The SW90-0004A is ideally suited for wireless infrastructure applications. 1. 2. Ordering Information Part Number Package SW90-0004A Bulk Packaging SW90-0004ATR 1000 piece reel SW90-0004A-TB Sample Test Board 3. 4. Pin No. Function Pin No. Function 1 CP2 19 GND 2 VEE 20 NC 3 NC 21 GND 4 C6 22 RFC 5 C5 23 GND 6 C4 24 GND 7 C3 25 RF4 8 C2 26 GND 9 C1 27 RF5 10 NC 28 GND 11 GND 29 RF6 12 NC 30 GND 13 GND 31 NC 14 RF1 32 VEE 15 GND 33 Vcc 16 RF2 34 NC 17 GND 35 Vcc 18 RF3 36 CP1 NC = No Connection For single supply operation VEE is internally generated and must remain isolated from external power supplies. Generated noise is typical of switching DC-DC Converters. Connections and external components shown in functional schematic are required. 0.1µF Capacitors need to be located near pins 32 & 33. The exposed pad centered on the package bottom must be connected to RF and DC ground. (For MLF Packages) Note: Reference Application Note M513 for reel size information. 1 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V8 Electrical Specifications: TA = 25°C Parameter Test Conditions Frequency Units Min. Typ. Max. Insertion Loss RFC-RF1, 2, 3, 4, 5, 6 DC - 3.0 GHz 3.0 - 4.0 GHz dB dB — — — — 2.1 2.4 Isolation — DC - 4.0 GHz dB 25 — — VSWR On (RFC, RF1-RF6) Logic per Truth Table Off (RF1-RF6) Logic per Truth Table DC - 4.0 GHz Ratio — — 2.0:1 DC - 4.0 GHz Ratio — — 2.0:1 1 dB Compression — — 50 MHz 0.5 - 4.0 GHz dBm dBm — — 15 27 — — Input IP3 Two-tone inputs up to +5 dBm 50 MHz 0.5-4.0 GHz dBm dBm — — 30 40 — — Switching Speed Ton (50% Control to 90% RF) — ns — 20 — Toff (50% Control to 10% RF) — ns — 15 — Trise (10% to 90% RF) — ns — 5 — Tfall (90% to 10% RF) — ns — 2 — Vcc — — V 4.5 5.0 5.5 VIL VIH LOW-level input voltage HIGH-level input voltage — — V V 0.0 2.0 — — 0.8 5.0 lin (Input Leakage Current) Vin = VCC or GND — uA -1.0 — 1.0 Icc 5,7 Vcc min to max, Logic “0” or “1” — mA — 5 8 Icc8 (Quiescent Supply Current) Vcntrl = VCC or GND — uA — 250 400 Turn-on Current6 For guaranteed start-up — mA — — 125 ΔIcc (Additional Supply Current Per TTL Input Pin) VCC = Max, Vcntrl = VCC - 2.1 V — mA — — 1.0 Switching Noise Generated from DC-DC Converter with recommended capacitors 3.5 MHz dBm — -93 — Thermal Resistance θjc — — °C/W — 15 — 5. 6. 7. 8. During turn-on, the device requires an initial start up current (Icc) specified as “Turn-on Current”. Once operational, Icc will drop to the specified levels. This is not applicable to dual supply operation. The DC-DC converter is guaranteed to start in 100 µs as long as the power supplies have the maximum turn-on current available for startup. For single supply operation For dual supply operation Truth Table (Switch) C1 1 0 0 0 0 0 Control Inputs "0" is TTL Low, "1" is TTL High C2 C3 C4 C5 0 1 0 0 0 0 0 0 1 0 0 0 0 0 0 1 0 0 0 0 0 0 1 0 C6 RF1 0 0 0 0 0 1 On Off Off Off Off Off Condition of Switch RF Common to Each RF Port RF2 RF3 RF4 RF5 Off On Off Off Off Off Off Off On Off Off Off Off Off Off On Off Off Off Off Off Off On Off RF6 Off Off Off Off Off On 2 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz Absolute Maximum Ratings 9,10 Parameter Recommended PCB Configuration Absolute Maximum Max. Input Power 0.05 GHz 0.5 - 4.0 GHz11 +27 dBm +34 dBm VCC7 -0.5V ≤ VCC ≤ +6.0V VCC8 -0.5V ≤ VCC ≤ +7.0V VEE8 -8.5V ≤ VEE ≤ +0.5V VCC - VEE8 -0.5V ≤ VCC - VEE ≤ 14.5V 12 -0.5V ≤ Vin ≤ VCC + 0.5V Vin Rev. V8 Operating Temperature -40ºC to +85ºC Storage Temperature -65ºC to +125ºC 9. Exceeding any one or combination of these limits may cause permanent damage to this device. 10. M/A-COM does not recommend sustained operation near these survivability limits. 11. When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm. 12. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. Typical Performance Curves Insertion Loss vs. Frequency - 4 0 °C Please observe the following precautions to avoid damage: 2.5 Static Sensitivity Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. Isolation (dB) vs. Frequency Insertion Loss (dB) Handling Procedures 3.0 + 2 5 °C 2.0 1.5 1.0 0.5 0.0 0 1000 2000 3000 4000 Frequency (MHz) On VSWR vs. Frequency R F OU T R F n- R F m, R F C - R F n 90 2.00 75 1.80 60 VSWR Isolation (dB) + 8 5 °C 45 RFC 1.60 1.40 30 1.20 15 1.00 0 0 0 3 1000 2000 3000 4000 1000 2000 3000 4000 Frequency (MHz) Frequency (MHz) ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V8 Typical Performance Curves IP3 Results 11 VSWR (Terminations) vs. Frequency R F OU T 45 IP 3 ( d B m ) 2.00 VSWR 1.80 1.60 1.40 40 35 30 25 20 15 1.20 0 1.00 0 1000 2000 Frequency (MHz) 3000 4000 500 1000 1500 2000 Frequency 11. All testing done with the second tone 5 MHz above the frequency on the plot, except for the 10 MHz point, where the second tone is at 11 MHz. Both tones are +5 dBm. Functional Schematic 4 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice. SW90-0004A GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz Rev. V8 CSP-2, 4 x 7 mm, 36-lead PQFN† † Reference Application Note M538 for lead-free solder reflow recommendations. 5 ADVANCED: Data Sheets contain information regarding a product M/A-COM Technology Solutions • North America Tel: 800.366.2266 • Europe Tel: +353.21.244.6400 is considering for development. Performance is based on target specifications, simulated results, • India Tel: +91.80.4155721 • China Tel: +86.21.2407.1588 and/or prototype measurements. Commitment to develop is not guaranteed. Visit www.macomtech.com for additional data sheets and product information. PRELIMINARY: Data Sheets contain information regarding a product M/A-COM Technology Solutions has under development. Performance is based on engineering tests. Specifications are typical. Mechanical outline has been fixed. Engineering samples and/or test data may be available. M/A-COM Technology Solutions Inc. and its affiliates reserve the right to make Commitment to produce in volume is not guaranteed. changes to the product(s) or information contained herein without notice.