ETC MB-7

MicroAmp MB-7 Circuit Board
For Passive Networks
FEATURES
• Generic layout for passive networks
• Easily create lumped element filters,
equalizers, bias networks,
attenuators, etc.
• Up to three series elements
• Up to eight parallel elements
• Accommodates 0603/0805 parts
• RO-4350 board material
• Fits MicroAmp MH-series housings
The MicroAmp MB-7 circuit board is designed for rapid prototyping of passive networks such as filters, attenuators, equalizers, bias
tees, etc. Passive elements such as resistors, capacitors, and inductors can be combined in a variety of series and shunt configurations. Networks can be easily designed and assembled with standard surface-mount passive components. It includes provisions for
three series elements and up to eight shunt elements in either 0603 or 0805 packages. This board will fit the MicroAmp MH series of
connectorized housings that allow it to be used as a single passive network or cascaded with other MicroAmp boards for added versatility. Boards are fabricated from a high-performance 13 mil thick RO-4350 laminate with RoHS compatible ENIG plating (electroless
nickel/immersion gold) on both the component side and the solid bottom ground plane. The board measures 0.490" x 0.590" and
mounts into the housing with four #1-72 screws. Pads for the RF connectors allow the SMA center pins to be easily soldered to the
board after it is installed into the housing.
REF
SIZE
S1-S3 0603/0805
P1-P8 0603/0805
J1
J2
FUNCTION
Series element
Parallel element
Input
Output
ASSEMBLY
NETWORK SCHEMATIC
For additional product information, please visit www.twinind.com
Contact information: 925-866-8946 (phone) 925-866-8937 (fax) [email protected]