Xeon 3 Power Blue LED OSB4XNE3E1E VER C.2 ■Features ■Outline ● Highest Luminous Flux ● Super Energy Efficiency ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance Dimension 3.6 BackView ■Applications Anode ● Read lights (car, bus, aircraft) ● Portable (flashlight, bicycle) ● Bollards / Security / Garden ● Traffic signaling / Beacons ● In door / Out door Commercial lights ● Automotive Ext ESD Protection Diode Unit:mm Tolerance:±0.30mm ■Absolute Maximum Rating Item ■Directivity (Ta=25℃) Symbol Value Unit DC Forward Current IF 800 mA Pulse Forward Current* IFP 1000 mA Reverse Voltage VR 5 V Power Dissipation PD 3200 mW Operating Temperature Topr -30 ~ +85 Storage Temperature Tstg -40~ +100 Lead Soldering Temperature Tsol 260 *Pulse width Max.10ms 0 0 ℃ ℃ ℃/5sec - Duty ratio max 1/10 ■Electrical -Optical Characteristics Item Cathode Symbol Condition ■Forward Operating Current (DC) (Ta=25℃ (Ta=25℃) Min. Typ. Max. Unit DC Forward Voltage IF=350mA 3.0 3.3 4.0 V IF=700mA 3.5 3.8 4.5 V VF DC Reverse Current IR VR=5V - - 10 µA Domi. Wavelength λD IF=700mA 455 460 465 nm Luminous Flux Φv IF=700mA 25 35 - lm 50% Power Angle 2θ1/2 IF=700mA - 140 - deg Forward Current, IF (mA) 800 700 600 500 400 300 200 100 RJ-A=30 RJ-A=25 RJ-A=20 RJ-A=15 ℃/W ℃/W ℃/W ℃/W 0 0 25 50 75 Ambient Temperature, TA ( Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series. LED & Application Technologies 100 ℃) 125 Xeon 3 Power Blue LED OSB4XNE3E1E VER C.2 ■ Soldering Heat Reliability (DIP): Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies