Xeon 1 Power Red Emitter OSR7XNE1E1E Ver.C.2 ■Features ■Outline ● Highest luminous flux ● Super energy efficiency ● Very long operating life ● Superior ESD protection Dimension ■Applications ● Green House Applications ● Red : Blue LED Iv Ratio is 8:1* Anode Cathode Unit:mm Tolerance:±0.30mm *The ratio is summarized by the photosynthesis test on Phalaenopsis and provided from plant workshop in Taiwan. ■Absolute (Ta=25℃) Maximum Rating Item ■Directivity Symbol Value Unit DC Forward Current IF 500 mA Pulse Forward Current* IFP 700 mA Reverse Voltage VR 5 V Power Dissipation PD 1500 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 0 0 *Pulse width Max.10ms, Duty ratio max 1/10 (Ta=25℃) -Optical Characteristics ■Forward Item Symbol Condition Min. Typ. Max. Unit DC Forward Voltage VF IF=350mA 2.0 2.5 3.0 V DC Reverse Current IR VR=5V - - 10 µA Peak Wavelength λP IF=350mA 650 660 670 nm Radiant Power Po IF=350mA 120 150 - mW 50% Power Angle 2θ1/2 IF=350mA - 140 - deg Operating Current (DC) 600 Forward Current, I F (mA) ■Electrical 500 400 RJ-A=30℃/W RJ-A=40℃/W RJ-A=50℃/W 300 200 100 0 0 10 20 30 40 50 60 70 80 90 100 Ambient Temperature, T A ( ) Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 emitter series. LED & Application Technologies VER A.0 Xeon 1 Power Red Emitter OSR7XNE1E1E VER C.2 ■ Soldering Heat Reliability : Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies VER A.0