OPTOSUPPLY OSY5XNE3E1E

Xeon 3 Power Yellow LED
OSY5XNE3E1E
VER C.2
■Features
■Outline
●
Highest Luminous Flux
●
Super energy efficiency
●
Long Lifetime Operation
●
Superior UV Resistance
Dimension
■Applications
●
Read lights (car, bus, aircraft)
●
Portable (flashlight, bicycle)
●
Bollards / Security / Garden
●
Traffic signaling / Beacons
●
In door / Out door Commercial lights
●
Automotive Ext
Anode
Cathode
Unit:mm
Tolerance:±0.30mm
■Absolute Maximum Rating
Item
■Directivity
(Ta=25℃)
Symbol
Value
Unit
DC Forward Current
IF
800
mA
Pulse Forward Current*
IFP
1000
mA
Reverse Voltage
VR
5
V
Power Dissipation
PD
2400
mW
Operating Temperature
Topr
-30 ~ +85
Storage Temperature
Tstg
-40~ +100
Lead Soldering Temperature
Tsol
260
*Pulse width Max.10ms
0
℃
℃
℃/5sec
-
Duty ratio max 1/10
■Electrical -Optical Characteristics
Item
0
Symbol
■Forward Operating Current (DC)
(Ta=25℃
(Ta=25℃)
Condition
Min.
Typ.
Max.
Unit
IF=350mA
2.0
2.3
3.0
V
IF=700mA
2.5
2.8
3.5
V
VR=5V
-
-
10
µA
DC Forward Voltage
DC Reverse Current
Domi. Wavelength
Luminous Flux
50% Power Angle
VF
IR
λD
585
590
595
nm
Φv
IF=700mA
IF=700mA
70
80
-
lm
2θ1/2
IF=700mA
Forward Current, IF (mA)
800
700
600
500
400
300
200
100
RJ-A=30
RJ-A=25
RJ-A=20
RJ-A=15
℃/W
℃/W
℃/W
℃/W
0
0
25
50
75
Ambient Temperature, TA (
-
140
-
Note: Don’t drive at rated current more than 5s without heat sink for Xeon 3 emitter series.
LED & Application Technologies
deg
100
℃)
125
Xeon 3 Power Yellow LED
OSY5XNE3E1E
VER C.2
■ Soldering Heat Reliability (DIP):
Reflow soldering Profile
· Reflow soldering should not be done more than two times.
· When soldering, do not put stress on the LEDs during heating.
· After soldering, do not warp the circuit board.
· Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used. It should be confirmed beforehand whether the
characteristics of the LEDs will or will not be damaged by repairing.
Solder
Average ramp-up rate = 3ºC/sec. max.
Preheat temperature: 150º~180ºC
Preheat time = 120 sec. max.
Ramp-down rate = 6ºC/sec. max.
Peak temperature = 220ºC max.
Time within 3ºC of actual
peak temperature = 25 sec. max.
Duration above 200ºC is 40 sec. max.
LED & Application Technologies