NuDAM 1 Software & Utilities 2 ND-6058 ND-6063 28-CH PPI Module 8-CH Relay Output Module Programmable I/O ■8255 programmable peripheral interface mode 0 emulation ■Channel: 24 ■Input Signal • TTL level ■Internal Pull-Up Resistor: 10 kΩ ■Maximum Current: 0.5 mA ■Output Signal • TTL level Digital Input ■Channels: 4 ■TTL level Power ■Requirement: unregulated +10 V to +30 VDC ■Power Consumption:1.488 W typical Connector ■50-pin female SCSI II DAQ 3 Relay Output ■Channels: 8 independent relay outputs ■Output Type: 8 form A ■Contact Rating • DC 1 A / 30 V • ON/OFF interval time: 3 ms (at 20°C) ■Internal Insulation ■Resistance: 1000 MΩ @ 500 VDC ■Expected Life: 2 x 105 (1 A 30 VDC resistive at 20 cpm) Power ■ Requirement: unregulated +10 V to +30 VDC ■ Power Consumption: 1.416 W typical 4 Modular Instruments 5 GPIB & Bus Expansion 6 Motion Control ND-6067 ND-6060 8-CH AC Relay Output Module Relay Output & Digital Input Module 7 Relay Output ■ Channels: 4 relay outputs ■ Output Type: 2 form C and 2 form A ■ Contact Rating: • DC 2A / 30 V ■ ON/OFF Interval Time: 3 ms ■ Internal Insulation Resistance: 1000 MΩ @ 500 VDC ■ Expected Life: 2 x105 (1 A 30 VDC resistive at 20 cpm) ■ Programmable output polarity ■ Programmable output power on/safety state Relay Output ■Channels: 5 independent relay outputs and 3 common source replay outputs ■Output type: 8 form A ■Contact rating: • AC 3 A / 250 V • DC 3 A / 30 V ■ON/OFF time interval: 6 ms/3 ms • Operate time: approx. 6 ms • Release time: approx. 3 ms ■Insulation resistance: 1000 MΩ minimum (at 500 VDC) ■Expected Life: 2 x 105 (3 A 250 VAC, 3 A 30 VDC at 20 cpm) Power ■Power Requirement: +10 V to +30 VDC Unregulated with against power reversal ■Power Consumption: 1.392 W typical Digital Input ■ Channels: 4 ■ Common External Voltage: +24 V ■ Current Limit Resistor: 2.2 kΩ ■ Isolation Voltage: 5000 VRMS ■ Input Type: dry contact ■ Programmable input polarity Power ■ Requirement: unregulated +10 V to +30 VDC ■ Power Consumption: 0.84 W typical ND-6080 2-CH Counter/Frequency Input Module PXI Real-time Distributed I/O 8 PAC 9 Remote I/O 10 Communications 11 Counter Inputs ■Channels: Two independent 32-bit counter ■Input Frequency: 20 KHz max. ■Input Mode: isolated or non-isolated ■Isolation Voltage: 5000 VRMS ■Isolation Input Level • Logical level 0: +1 V max • Logical level 1: 3.5 V to 30 V ■Current Limit Resistor: 1.2 kΩ ■Non-isolated Input Level programmable threshold • Logical l level 0: 0 V to +5 V (default = 0.8 V) • Logical level 1: 0 V to +5 V (default = 2.4 V) ■Input Pulse Width: > 5 μs ■Max Count: 4,294,967,295 (32-bit) ■Programmable Digital Noise Filter: 4 μs to 1.02 ms ■Alarm: alarm comparator on each counter Frequency Measurement ■Range: 1 Hz to 20 KHz ■Programmable built-in gate time: 1.0 / 0.1 s Digital Output ■Channels: 2 ■Open collector to 30 V, 30 mA max. load Power ■Requirement: unregulated +10 V to +30 VDC ■Power Consumption: 2.016 W Vision 12 Fanless Embedded Computers 13 cPCI & Industrial Computers www.adlinktech.com 9-6